L76 文本准备与交换 标准查询与下载

ISO/IEC 9529-2:1989 信息处理系统 数据交换用90mm(3.5 in)改进调频制记录的密度为15916 ftprad、每面80道的软磁盘 第2部分:磁道格式

Determines the track layout, the track format and the characteristics of the recorded signals for the data interchange on 90 mm (3,5 in) flexible disk cartridge using modified freqency modulation recording at 15916 ftprad on 80 tracks on each side. References: ISO 646; 2022; 4873; 6429; 8859; 9293.

Information processing systems; data interchange on 90 mm (3,5 in) flexible disk cartridges using modified frequency modulation recording at 15916 ftprad, on 80 tracks on each side; part 2: track format

ISO 8613-5:1989 信息处理.文本和办公文件体制.办公文件体系结构和互换格式.第5部分:办公文件交换格式(ODLF)

Information processing; text and office systems; Office Document Architecture (ODA) and interchange format; part 5: Office Document Interchange Format (ODIF)

ISO 8613-4:1989 信息处理.文本和办公文件体制.办公文件体系结构和互换格式.第4部分:文件提问档

Information processing; text and office systems; Office Document Architecture (ODA) and interchange format; part 4: document profile

BS 7138:1989 标准通用记账语言（SGML）文件交换格式(SDIF)指南

Permits documents marked up using SGML, and related documents, to be packed into a data stream, interchanged, and then split again into separate entities. Interchange can be by means of data communications in Open Systems Interconnection or other environments , or by the exchange of storage media.

Guide to SGML Document Interchange Format (SDIF)

CSA Z243.210-89-CAN/CSA-1989 信息处理- 文本办公系统-标准无特异语言(SGML),SGML支持设施- SGML 文件交换格式SDIF) ISO 8879,9069

This is the first edition of CSA Standard CAN/CSA-Z243.21 O, Information Processing- Text and Office Systems-Standard Generalized Markup Language (SG ML), and SGML Support Facilities-SG ML Document Interchange Format (SDIF).

Information Processing - Text and Office Systems - Standard Generalized Markup Language (SGML), and SGML Support Facilities - SGML Document Interchange Format (SDIF) First Edition

ISO 9543:1989 信息处理系统 系统间远程通信和信息交换 DTE/DCE接口处同步传输的信号质量

Prescribes quality requirements for serial data transmission at the interface between synchronous transmission Data Terminal Equipment and Data Circuit-terminating Equipment in conformance with the CCITT Recommendations V.24 (telephone networks), X.24 (data networks) as specified in DCEs of the corresponding CCITT-Recommendations. Takes into account the need to have performance cotegories of signal quality depending on the type of interchange circuits.

Information processing systems; information exchange between systems; synchronous transmission signal quality at DTE/DCE interfaces

JIS X 4001:1989 日语文件互换的文件规范(基本型)

この規格は，日本語ワードプロセッサ又はこれと同等の能力をもつ情報処理機器相互間でフレキシプルディスクカートりッジを用いて，文字を基本とする日本語文書の交換を行う場合の文書フアィルの仕様について規定する。

File specification for Japanese documents interchange (Basic type)

JIS X 4003:1989 日语文件互换的文件规范(几何学图形)

この規格は，日本語ワードプロセッサ又はこれと同等の機能をもつ情報処理機器相互間でフレキシプルディスクカートリッジを用いて，文字及び幾何学図形を基本とする日本語文書の文換を行う場合の文書ファイルの仕様について規定する。

File specification for Japanese documents interchange (Geometric graphics)

JIS X 4004:1989 日语文件互换的文件规范(光栅图形型)

この規格は，日本語ワードプロセッサ又はこれと同等の機能をもつ情報処理機器相互間でフレキシプルディスクカートリッジを用いて，文字及びニ値図形を基本とする日本語文書の交換を行う場合の文書ファィルの仕様について規定する。

File specification for Japanese documents interchange (Raster graphics type)

ISO/IEC TR 10029:1989 信息技术 系统间远程通信和信息交换 X.25互工作单元的操作

Describes the function of the Interworking unit (IWU) in terms of the mapping between Protokol Data Units (PDUs) that it receives from one interface, and PDUs that it then transmits which could be on either interface of the IWU. Also describes procedures an IWU can initiate on each interface independently. Each interface corresponds to one instance of a DTE/DXE connection, and both interfaces of the Interworking Unit operate as a DTE as specified by ISO 8208. References: ISO 8208; 8880-2; 8881.

Information technology; Telecommunications and information exchange between systems; operation of an X.25 interworking unit

ANSI/ISO 9069:1988 信息处理.SGML支持设施.INCITS采纳的SGML文件交换格式(SDIF)

This International Standard specifies a data structure known as the SGML Document Interchange Format (SDIF). SDIF enables a document conforming to ISO 8879, which might be stored in several entities, to be packed intoa data stream for interchange in a manner that will permit the recipient to reconstitute the separate entities. SDIF also allows related documents to be included in the data stream, such as covering letters, transmittal forms, catalog cards, formatting procedures, or the "document profile" required by a document architecture.

Information Processing - SGML Support Facilities - SGML Document Interchange Format (SDIF) Adopted by INCITS

ISO 9069:1988 信息处理 SGML支持设施 SGML文件交换格式(SDIF)

This International Standard specifies a data struc-ture known as the SGML Document Interchange Format (SDIF). SDIF enables a document conform-ing to ISO 8879, which might be stored in several entities, to be packed into a data stream for inter-change in a manner that will permit the recipient to reconstitute the separate entities. SDIF also allows related documents to be included in the data stream, such as covering letters, trans-mittal forms, catalog cards, formatting procedures, or the "document profile" required by a document architecture.

Information processing; SGML support facilities; SGML document interchange format (SDIF)

ISO 9661:1988 信息处理.在12.7mm(0.5in)盒式磁带上数据交换.每毫米18磁道、1491数据字节(每英寸37871 数据字节)

Information processing; data interchange on 12,7 mm (0.5 in) wide magnetic tape cartridges: 18 tracks, 1491 data bytes per millimetre (37871 data bytes per inch)

ANSI/INCITS/ISO 9069:1988 信息处理.SGML支持设施.SGML文件交换格式(SDIF)

This International Standard specifies a data structure known as the SGML Document Interchange Format (SDIF). SDIF enables a document conforming to ISO 8879, which might be stored in several entities, to be packed intoa data stream for interchange in a manner that will permit the recipient to reconstitute the separate entities. SDIF also allows related documents to be included in the data stream, such as covering letters, transmittal forms, catalog cards, formatting procedures, or the "document profile" required by a document architecture.

Information Processing - SGML Support Facilities - SGML Document Interchange Format (SDIF)

ITU-T Z.317-1988 人机对话过程

Man-machine communication comprises two types of information interchange, namely dialogue and output outside dialogue; they occur sequentially and in no particular order. Output outside dialogue is fully defined in Recommendation Z.316. Dialogue is that part of man-machine communication initiated and, normally, terminated by the user. It is accomplished by means of the dialogue procedures described in this Recommendation. In the text, the terms “dialogue” and “dialogue procedure” are used interchangeably. The text in § 2 describes the dialogue procedure, the syntax diagrams of which are given in § 3 in sub-divisions having numbers corresponding to those used in § 2. A systematic analysis of possible errors made by users is not considered. Diagrams mainly refer to correctly given commands and only obvious error situations are considered. It is recognized that the diagrams are not exhaustiveand some of them might be modified when error recovery procedures have been completely considered.

MAN-MACHINE DIALOGUE PROCEDURES

DIN 66029:1987 数据交互用的磁带上的标签和文件结构

This standard specifies the file structure and the labelling of magnetic tapes for the interchange of information between users of information processing systems.

Magnetic tape labelling and file structure for data interchange

JIS X 4002:1987 日语文件互换的文件规范(事务图形型)

この規格は，日本語ワードプロセッサ又は同等の能力をもつ情報処理機器の相互間でフレキップルディスクカートリグジを用いて，文字及び事務用グラフを基本とする日本語文書の交換を行う場合の文書ファイルの仕様について規定する。

File specification for Japanese documents interchange (business graph type)

ISO 4057:1986 信息处理 数据交换用6.30mm(0.25 in)宽盒式磁带,63 bpmm(160 bpi)调相制

Outlines the characteristics of a 6.30 mm (0,25 in) magnetic tape cartridges intended for data interchange and physical interchangeability between information processing systems utilizing the ISO 7-bit coded character set (ISO 646), its extensions (ISO 2022) and/or 8-bit character set (ISO 4873). The cartidge is of the twin-hub coplanar type, loaded with 6,30 mm (0,25 in) magnetic tape tor digital recording using the 53 bpmm (1600 bpi) phase-encoding method.

Information processing; Data interchange on 6,30 mm (0.25 in) magnetic tape cartridge, 63 bpmm (1 600 bpi) phase-encoded

ANSI/INCITS/ISO 8879:1986 信息处理.文本和办公系统.标准通用置标语言(SGML)

This International Standard specifies an abstract syntax known as the Standard Generalized Markup Language (SGML). The language expresses the description of a document's structure and other attributes, as well as other information that makes the markup interpretable.

Information Processing - Text and Office Systems - Standard Generalized Markup Language (SGML)

ISO 3407:1983 信息处理 信息交换用3.81mm(0.150 in)盒式磁带以4 cpmm(100 cpi)、63 ftmm(1600 ftpi)调相记录

Defines the characteristics of a 3.81 mm (0.150 in) magnetic tape cassette to provide data interchange and physical interchangeability between information processing systems utilizing the ISO 7-bit coded character set (ISO 646) and its extensions (ISO 2022). The cassette is of the twin hub coplaner type, loaded with 3.81 mm (0.150 in) wide magnetic tape for digital recording using the 31.5 bits per mm (800 bpi) phase encoding method. The direction of magnetization is in the longitudinal direction of the tape.

Information processing; Information interchange on 3,81 mm (0.150 in) magnetic tape cassette at 4 cpmm (100 cpi), phase encoded at 63 ftpmm (1 600 ftpi)