N09 卫生、安全、劳动保护 标准查询与下载

EN 13160-4:2016 检漏系统-第4部分:基于传感器的泄漏检测系统的要求和测试/评估方法

This European Standard gives requirements and the corresponding test/assessment methods applicable to sensor based leak detection systems (leak detection kits). The leak detection kits are intended to be used in interstitial spaces, leakage containments or monitoring wells. The leak detection kits are usually composed by: - sensing device(s); - evaluation device; - alarm device.

Leak detection systems - Part 4: Requirements and test/assessment methods for sensor based leak detection systems

EN 13160-1:2016 检漏系统-第1部分:一般原则

This European Standard specifies the general principles for leak detection systems for use with double-skin, single-skin, underground or above ground tanks and pipework designed for water polluting fluids.

Leak detection systems - Part 1: General Principles

EN 13160-6:2016 检漏系统-第6部分:监测井中传感器

This European Standard specifies the requirements for leak detection systems - class V for use with systems designed for fuels that are flammable, having a flash point up to but not exceeding 100 °C.

Leak detection systems - Part 6: Sensors in monitoring wells

EN 13160-7:2016 检漏系统-第7部分:填隙空间,检漏衬里和检漏夹克的要求和试验/评定方法

This European Standard gives requirements and the corresponding test/assessment methods applicable to leak detection lining kits and leak detection jacket kits. Leak detection lining kits and leak detection jackets kits intended to be used to create an interstitial space or leakage containment in single skin underground or above ground, non-pressurized, tanks designed for water polluting liquids. The kit has to be used only in conjunction with leak detection kits covered by EN 13160-2 to EN 13160-4.

Leak detection systems - Part 7: Requirements and test/assessment methods for interstitial spaces@ leak detection linings and leak detection jackets

EN 13160-5:2016 检漏系统-第5部分:油槽仪表系统和增压管道系统的要求和测试/评估方法

This European Standard gives requirements and corresponding testassessment methods applicable to leak detection kits, based on volumetric loss from within the tank and/or pipework system. The kits usually comprise: - Measuring Device; - Evaluation Device; - Alarm Device Intended use: Leak Detection kits are intended to be used inwith single or double skin underground tanks or single or double skin underground and/or aboveground pipework designed for flammable liquids having a flash point not exceeding 100 °C.

Leak detection systems - Part 5: Requirements and test/assessment methods for in-tank gauge systems and pressurised pipework systems

EN 13160-2:2016 泄漏检测系统-第2部分:压力和真空系统的要求和测试/评估方法

This European Standard gives requirements and the corresponding test/assessment methods applicable to leak detection kits (leak detector) based on the measurement of pressure change. Leak detection kits are intended to be used with double skin, underground or above ground, pressurized or non-pressurized, tanks or pipework designed for water polluting liquids/fluids. The kits are usually composed of: - measuring device; - evaluation device; - alarm device; - pressure generator; - pressure relief device; - liquid stop device; - condensate trap.

Leak detection systems - Part 2: Requirements and test/assessment methods for pressure and vacuum systems

EN 13160-3:2016 检漏系统-第3部分:坦克液体系统的要求和测试/评估方法

This European Standard gives requirements and the corresponding test/assessment methods applicable to leak detection kits based on the drop of the liquid level in the leak detection liquid reservoir. Leak detection kits are intended to be used with double skin, underground or above ground, non-pressurized, tanks designed for water polluting liquids. The liquid leak detection kits are usually composed of: - sensing device (liquid sensor); - evaluation device; - alarm device.

Leak detection systems - Part 3: Requirements and test/assessment methods for liquid systems for tanks

AQ/T 6207-2007 便携式载体催化甲烷检测报警仪

Portable carrier catalytic methane detection and alarm instrument

AQ/T 6209-2007 数字式甲烷检测报警矿灯

Digital methane detection and alarm miner's lamp

BS IEC 61010-3-020:1999 测量、控制和实验室用电气设备的安全要求.满足IEC 61010-2-020:1992：实验室离心机的特殊要求的合格鉴定报告

Safety requirements for electrical equipment for measurement, control, and laboratory use — Part 3-020: Conformity verification report for IEC 61010-2-020:1992, Particular requirements for laboratory centrifuges FOREWORD Conformity verification report IEC 61010-2-020 Clause 5 Marking and documentation 6 Protection against electric shock 7 Protection against mechanical hazards 8 Mechanical resistance to shock, vibration and impact Mechanical resistance to shock and impact (IEC 61010-1 with amendment 2) 9 Equipment temperature limits and protection against the spread of fire 10 Resistance to heat 11 Resistance to moisture and liquids Protection against hazards from fluids (IEC 61010-1 with amendment 2) 12 Protection against radiation, including laser sources, and against sonic and ultrasonic pressure 13 Protection against liberated gases, explosion and implosion and escape of microbiological materials 14 Components 15 Protection by interlocks 16 Measuring circuits Annex K - Routine tests Tables 1 Documents attached to this report 2 Test equipment list 3 List of components relied on for safety Form A.1 to Form A.37

Safety requirements for electrical equipment for measurement, control, and laboratory use - Conformity verification report for IEC 61010-2-020:1992, particular requirements for laboratory centrifuges

BS IEC 61010-3-061:1999 测量、控制和实验室用电气设备的安全要求.IEC 61010-2-061的合格鉴定报告.带有热雾化和电离的实验室原子分光仪的特殊要求

Safety requirements for electrical equipment for measurement, control, and laboratory use — Part 3-061: Conformity verification report for IEC 61010-2-061, Particular requirements for laboratory atomic spectrometers with thermal atomization and ionzation FOREWORD Conformity verification report IEC 61010-2-61 Clause 5 Marking and documentation 6 Protection against electric shock 7 Protection against mechanical hazards 8 Mechanical resistance to shock, vibration and impact (AM 1 only) Mechanical resistance to shock and impact (AM 2) 9 Equipment temperature limits and protection against the spread of fire 10 Resistance to heat 11 Resistance to moisture and liquids (AM 1 only) Protection against hazards from fluids (AM 2) 12 Protection against radiation, including laser sources, and against sonic and ultrasonic pressure 13 Protection against liberated gases, explosion and implosion 14 Components 15 Protection by interlocks 16 Measuring circuits Annex K Routine tests Tables 1 Documents attached to this report 2 Test equipment list, 3 List of components relied on for safety Form A.1 to Form A.29

Safety requirements for electrical equipment for measurement, control, and laboratory use - Conformity verification report for IEC 61010-2-061, particular requirements for laboratory atomic spectrometers with thermal atomization and ionization

BS IEC 61010-3-051:1999 测量、控制和实验室用电气设备的安全要求.IEC 61010-2-051的合格鉴定报告.混合和搅拌用实验室设备的特殊要求

Safety requirements for electrical equipment for measurement, control, and laboratory use — Part 3-051: Conformity verification report for IEC 61010-2-051, Particular requirements for laboratory equipment for mixing and stirring FOREWORD Conformity verification report for IEC 61010-2-051 Clause 5 Marking and documentation 6 Protection against electric shock 7 Protection against mechanical hazards 8 Mechanical resistance to shock, vibration and impact (AM1 only) Mechanical resistance to shock and impact (AM 2) 9 Equipment temperature limits and protection against the spread of fire 10 Resistance to heat 11 Resistance to moisture and liquids (AM1 only) Protection against hazards from fluids (AM 2) 12 Protection against radiation, including laser sources, and against sonic and ultrasonic pressure 13 Protection against liberated gases, explosion and implosion 14 Components 15 Protection by interlocks 16 Measuring circuits Annex K Routine tests Tables 1 Documents attached to this report 2 Test equipment list 3 List of components relied on for safety Form A.1 to Form A.29

Safety requirements for electrical equipment for measurement, control, and laboratory use - Conformity verification report for IEC 61010-2-051, particular requirements for laboratory equipment for mixing and stirring

BS IEC 61010-3-010:1999 测量、控制和实验室用电气设备的安全要求.满足IEC 61010-2-010：.材料加热用实验室设备的特殊要求的合格鉴定报告

Safety requirements for electrical equipment for measurement, control, and laboratory use — Part 3-010: Conformity verification report for IEC 61010-2-010, Particular requirements for laboratory equipment for the heating of materials FOREWORD Conformity verification report for IEC 61010-2-010 Clause 5 Marking and documentation 6 Protection against electric shock 7 Protection against mechanical hazards 8 Mechanical resistance to shock and impact 9 Equipment temperature limits and protection against the spread of fire 10 Resistance to heat 11 Protection against hazards from fluids 12 Protection against radiation, including laser sources, and against sonic and ultrasonic pressure 13 Protection against liberated gases, explosion and implosion 14 Components 15 Protection by interlocks 16 Measuring circuits Annex K Routine tests Tables 1 Documents attached to this report 2 Test equipment list 3 List of components relied on for safety Form A.1 to Form A.29

Safety requirements for electrical equipment for measurement, control, and laboratory use - Conformity verification report for IEC 61010-2-010, particular requirements for laboratory equipment for the heating of materials

DIN 12899-3:1992 应急设备.应急喷淋装置.生产地点内外的淋浴器.安全要求、试验

The document specifies requirements for body showers intended to flush contaminated or burning people with sufficient amount of water and is applicable for body showers in internal and external production places.

Emergency equipment; emergency shower installations; body showers in internal and external production places; safety requirements, tests

prEN 61010-1-1992 测量.控制和实验室用电气设备的安全要求.第1部分:一般要求

Safety requirements for electrical equipment for measurement, control and laboratory use; part 1: general requirements (IEC 1010-1:1990 + future A1, modified)

prEN 60079-19-1992 防爆电工仪器.第19部分:用于爆炸气氛中的仪器的(修理地雷或炸药除外)

Electrical apparatus for explosive gas atmospheres; part 19: repair and overhaul for apparatus used in explosive atmospheres (other than mines or explosives)