P24 砌体结构工程 标准查询与下载
共找到 362 条与 砌体结构工程 相关的标准，共 25 页
Methods of test for ancillary components for masonry. Determination of tensile and compressive load capacity and load displacement characteristics of wall ties (single end test)
- ICS
- 91.080.30
- CCS
- P24
- 发布
- 2012-08-31
- 实施
- 2012-08-31
Building works - Small mansonry unit walls - Partitions and walls - Part 1-1 : contract bill of technical model clauses.
- ICS
- 91.060.10;91.080.30
- CCS
- P24
- 发布
- 2012-07-01
- 实施
- 2012-07-27
Masonry and masonry products - Methods for determining thermal properties.
- ICS
- 91.080.30;91.120.10
- CCS
- P24
- 发布
- 2012-07-01
- 实施
- 2012-07-20
Building work - Small mansonry unit walls - Partitions and walls - Part 4 : calculation rules and minimum construction provisions.
- ICS
- 91.060.10;91.080.30
- CCS
- P24
- 发布
- 2012-07-01
- 实施
- 2012-07-27
Building work - Small mansonry unit walls - Partitions and walls - Part 3 : guide for selection of site-dependent façade wall types.
- ICS
- 91.060.10;91.080.30
- CCS
- P24
- 发布
- 2012-07-01
- 实施
- 2012-07-27
Masonry and masonry products. Methods for determining thermal properties
- ICS
- 91.080.30;91.120.10
- CCS
- P24
- 发布
- 2012-04-30
- 实施
- 2012-04-30
Specification for masonry units - Part 3 : Aggregate concrete masonry units (Dense and light-weight aggregates) - National addition to NF EN 771-3:2011.
- ICS
- 91.080.30;91.100.30
- CCS
- P24
- 发布
- 2012-03-01
- 实施
- 2012-03-22
为使混凝土空心砖在工程施工中做到技术先进、经济合理、确保质量、安全适用，特制定本规程。 本规程适用于在安徽省内使用混凝土空心砖作为填充墙砌体工程施工的一般工业与民用建筑。 本规程依据《非承重混凝土空心砖》GB/T 24492、《混凝土小型空心砌块建筑技术规程》JGJ/T 14、《建筑工程施工质量验收统一标准》GB 50300、《砌体工程施工质量验收规范》GB 50203 和安徽省标准图集《非承重混凝土空心砖、复合保温砖墙体建筑构造》皖 2010J122，并结合混凝土空心砖实际施工经验编制。
Construction quality and acceptance regulations of concrete hollow brick masonry project
- ICS
- 91.080.30
- CCS
- P24
- 发布
- 2012-02-23
- 实施
- 2012-03-23
本规程适用于非抗震地区和抗震设防烈度为6至8度地区新建、改建和扩建的民用建筑采用非承重混凝土复合保温砖砌体工程的房屋建筑设计、施工及验收。新建工业建筑和既有建筑节能改造可参考执行。 本规程依据《非承重混凝土空心砖》GB/T 24492、《混凝土复合隔热保温砖》Q/DSJC 08、《混凝土小型空心砌块建筑技术规程》JGJ/T 14、《建筑工程施工质量验收统一标准》GB 50300、《砌体工程施工质量验收规范》GB 50203 和安徽省标准图集《非承重混凝土空心砖、复合保温砖墙体建筑构造》皖2010J122，
Application technical specification for self-insulation system of non-load-bearing concrete composite insulation bricklaying
- ICS
- 91.080.30
- CCS
- P24
- 发布
- 2012-02-23
- 实施
- 2012-03-23
National Annex - Nationally determined parameters - Eurocode 6: Design of masonry structures - Part 1-1: General rules for reinforced and unreinforced masonry structures
- ICS
- 91.010.30;91.080.30
- CCS
- P24
- 发布
- 2012-01
- 实施
National Annex - Nationally determined parameters - Eurocode 6: Design of masonry structures - Part 2: Design considerations, selection of materials and execution of masonry
- ICS
- 91.010.30;91.080.30
- CCS
- P24
- 发布
- 2012-01
- 实施
National Annex - Nationally determined parameters - Eurocode 6: Design of masonry structures - Part 3: Simplified calculation methods for unreinforced masonry structures
- ICS
- 91.010.30;91.080.30
- CCS
- P24
- 发布
- 2012-01
- 实施
Technical specification for construction of plant fiber industrial ash concrete block
- ICS
- CCS
- P24
- 发布
- 2011-10-01
- 实施
- 2011-10-01
本规程适用于非抗震地区和抗震设防烈度为6度至9度地区，以混凝土小型空心砌块为墙体材料的房屋建筑的设计、施工及工程质量验收。
Technical specification for concrete small-sized hollow block masonry building
- ICS
- CCS
- P24
- 发布
- 2011-08-29
- 实施
- 2012-04-01
Specification for masonry units - Part 3 : aggregate concrete masonry units (Dense and light-weight aggregates).
- ICS
- 91.100.30
- CCS
- P24
- 发布
- 2011-08-01
- 实施
- 2011-08-06
This European Standard specifies the characteristics and performance requirements for masonry units manufactured from clay for use in masonry construction (e. g. facing and rendered masonry, loadbearing or non-loadbearing masonry structures, including internal linings and partitions, for building and civil engineering).
Specification for masonry units - Part 1: Clay masonry units; German version EN 771-1:2011
- ICS
- 91.100.25
- CCS
- P24
- 发布
- 2011-07
- 实施
This European Standard specifies the characteristics and performance requirements of autoclaved aerated concrete (AAC) masonry units for which the main intended uses are different types of load bearing and non load bearing applications in all forms of walling including single leaf, cavity, partitions, retaining, basement and general use below ground level, including walling for fire protection, thermal insulation, sound insulation and the fabric of chimneys (excluding chimney flue units).
Specification for masonry units - Part 4: Autoclaved aerated concrete masonry units; German version EN 771-4:2011
- ICS
- 91.100.30
- CCS
- P24
- 发布
- 2011-07
- 实施
This European Standard specifies a method of determining the water absorption of clay and calcium silicate masonry units by immersing them in cold water.
Methods of test for masonry units. Determination of water absorption of clay and calcium silicate masonry units by cold water absorption
- ICS
- 91.100.15
- CCS
- P24
- 发布
- 2011-05-31
- 实施
- 2011-05-31
This European Standard specifies a method of determining the freeze-thaw resistance of calcium silicate masonry units.
Methods of test for masonry units. Determination of freeze-thaw resistance of calcium silicate masonry units
- ICS
- 91.080.30;91.100.25
- CCS
- P24
- 发布
- 2011-05-31
- 实施
- 2011-05-31
This European Standard specifies a method of determining the water absorption coefficient due to capillary action for aggregate concrete, autoclaved aerated concrete, natural stone and manufactured stone masonry units and the initial rate of water absorption for clay masonry units.
Methods of test for masonry units. Determination of water absorption of aggregate concrete, autoclaved aerated concrete, manufactured stone and natural stone masonry units due to capillary action and the initial rate of water absorption of clay masonry un
- ICS
- 91.100.15;91.100.30
- CCS
- P24
- 发布
- 2011-05-31
- 实施
- 2011-05-31
