共找到 410 条与 照明与信号设备 相关的标准,共 28 页
The General Services Administration has authorized the use of this commercial item description as a replacement for Military Specifications MIL-V-16720E and MIL-V-16721D which are cancelled.
STOPLIGHT, VEHICULAR-BLACKOUT, 24 VOLT
VOR OESCN A IURE P“RPU5CS. iSTA”CWW TAKES PRECWENCE OVER PRDCUREMEN 1 CXCU”EN lS RUF.RENCZC HEREQ4. SSIX IN .CFFECT 0“ DATE 5 !NWIAWNS FOR Bit
LIGHT - NAVIGATIONAL AND WARNING, AIRCRAFT
License Plate Lamps (Rear Registration Plate Lamps)
Specifies the requirements (position and orientation) for the main-beam headlamp, dipped-beam headlamp, front position lamp, side and rear reflex-reflecting device, direction indicator lamp, stop lamp, rear position lamp, rear registration plate lamp, hazard warning lamp, front fog lamp, rear fog lamp.
Two-wheeled motorcycles; positioning of lighting and light-signalling devices
This SAE Recommended Practice provides laboratory test procedures for testing headlamp aim test machines to determine their ability to aim or to check the aim of headlamps, fog lamps, and auxiliary driving and lower beam lamps. This report does not apply to aiming devices of the kind covered by SAE J602.
Headlamp Aim Testing Machines
Specifies the dimensional, mechanical and optical quality criteria for equipment to measure or to verify the orientation of the luminous beams emitted by the headlamps installed on road motor vehicles excluding mopeds and motorcycles. The equipment also allows evaluation of the quality of the luminous beams by visual means. Lays down the requirements for the floor on which the vehicles are placed, the vehicle preparation, equipment using a distant screen, optical equipment with installation and operating instructions, photometric devices.
Road vehicles; measurement equipment for orientation of headlamp luminous beams
This SAE Recommended Practice applies to motor vehicle forward illumination systems which use light generated by discharge sources. It provides test methods, requirements, and guidelines applicable to the special characteristics of gaseous discharge lighting devices which supplement those required for forward illumination systems using incandescent light sources. The document is applicable to integral beam and replaceable component discharge forward lighting systems. This document is intended to be a guide to standard practice and is subject to change to reflect additional experience and technical advances.
Discharge Forward Lighting System
The document is applicable to motor vehicle bulbs with single filament used for head lamps, types E and Q.#,,#
Lamps for road vehicles; motor vehicle single filament bulbs for headlamps
The document is applicable to motor vehicle bulbs with single filament used for signal lamps, types R and U.#,,#
Lamps for road vehicles; motor vehicle single filament lamps for signal lamps
Lamps for road vehicles; motor vehicle bulbs with socket W2
This SAE Recommended Practice provides standardized laboratory tests, test methods, and requirements applicable to many of the lighting devices and components covered by SAE Recommended Practices and Standards and is intended for reference for devices used on vehicles less than 2032 mm in width, regardless of length, or 7620 mm in length regardless of width. Tests for vehicles larger than 2032 mm in overall width are covered in J2139.
Test Methods and Equipment for Lighting Devices and components for Use on Vehicles Less Than 2032 mm in Overall Width
Presents a compilation of legal specifications of the United Nation Conference of Road Traffic, North America, Europe, Australia and Japan and shall be used when the lighting and light signalling devices of ISO 303 are designed and installed into the various road vehicles. Furthermore, the document gives the main difference between the listed requirements as well as specific national regulations and should be used for further harmonization.
Road vehicles; legal situation concerning lighting and light-signalling devices
Lamps for road vehicles; dimensional, electrical and luminous requirements (IEC 809:1985 + AMD 1:1987 + AMD 2:1989, modified)
Lamps for road vehicles; motor vehicle lamps up to 15 W for signal and other lamps
Lamps for road vehicles; performance requirements; amendment 2
Road vehicle lamps for supplementary purposes (IEC 983:1990)
Establishes a comparison of regulations on the requirements for devices to be installed into road vehicles and their trailers. May be applied in the lack of detailed specifications.
Road vehicles; comparison tables of regulations on photometric requirements of light signalling devices
Road vehicle lamps for supplementary purposes; amendment 1
The General Services Administration has authorized the use of this commercial item description as a replacement for Military Specifications MIL-V-16720E and MIL-V-16721D which are cancelled.
LIGHT, DOME: 24 VOLT DC
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号