U37 小型船专用装备 标准查询与下载

GB/T 11702-1989 小艇 污水接头

本标准规定了小艇污水接头的主要特征。 本标准适用于小艇的生活污水排放。

Small craft waste water fittings

GB 11700-1989 小艇 船用推进发动机及其装置的功率测定及报告书

Small craft--Marine propulsion engines and system-power measurements and declarations

GB 11699-1989 小艇 舷内机桨轴端和桨毂

Small craft--Inboard engine-propeller shaft ends and bosses

ISO 8847:2021 小艇. 操舵装置. 滑轮系统上的缆索

This document specifies the requirements for the design, installation and testing of cable over pulley steering systems on small craft with or without a propulsion engine(s), and on small craft with outboard engine(s) up to and including 37 kW total power. It specifies the requirements for the design and testing of all components of a cable over pulley steering system, from the steering mechanism to the mechanical interface with the rudder shaft or the outboard engine. It applies to cable over pulley steering systems, whether for pedestal or bulkhead types. This document does not address emergency means of steering the craft.

Small craft - Steering gear - Cable over pulley systems

ISO 8099-2:2020 小艇. 废物系统. 第2部分: 污水处理系统

This document specifies requirements for the design, construction and installation of sewage treatment systems on small craft. It does not address waste retention systems, nor accidental discharge prevention of pollutants (e.g. oil, fuel) overboard. It does not address the technical discharge limits of a sewage treatment unit, subject to certain international as well as national regulations.

Small craft - Waste systems - Part 2: Sewage treatment systems

ISO 8848:2020 小艇. 遥控机械操舵系统

Small craft - Remote mechanical steering systems

ISO 23411:2020 小艇. 方向盘

This document specifies design and testing requirements for steering wheels for small craft.

Small craft - Steering wheels

NF J95-046-7:2020 小艇. 船体构造和构件尺寸. 第7部分: 根据ISO 12215-5确定多体船载荷及其局部构件尺寸

Domaine d'applicationCe document définit les dimensions, les pressions de conception locales et les charges globales agissant sur les bateaux multicoques d'une longueur de coque (LH) ou une longueur de référence jusqu'à 24 m (voir la Note) . Il prend en compte toutes les parties

Small craft - Hull construction and scantlings - Part 7 : determination of loads for multihulls and of their local scantlings using ISO 12215-5

NF J95-046-10:2020 小艇. 船体构造和构件尺寸. 第10部分: 帆艇的帆装载荷及帆装附件

Le présent document spécifie des méthodes pour la détermination:- des charges de conception et des contraintes de conception dans les éléments du gréement; et- des charges et des échantillonnages des points d'attache du gréement et du pied de mât/épontille;sur les voiliers monoco

Small craft - Hull construction and scantlings - Part 10 : rig loads and rig attachment in sailing craft

ISO 12215-7:2020 小艇. 船体结构和构件尺寸. 第7部分: 使用ISO 12215-5测定多体船的载荷及其局部构件尺寸

This document defines the dimensions, local design pressures and global loads acting on multihull craft with a hull length (LH) or load line length of up to 24 m (see Note). It considers all parts of the craft that are assumed watertight or weathertight when assessing stability, freeboard and buoyancy in accordance with ISO 12217 (all parts). Scantlings corresponding to the local design pressures are then assessed using ISO 12215-5. NOTE The load line length is defined in the OMI "International Load Lines Convention 1966/2005", it can be smaller than LH for craft with overhangs. This length also sets up at 24 m the lower limit of several IMO conventions. This document is applicable to multihulls built from the same materials as in ISO 12215-5, in intact condition, and of the two following types: — recreational craft, including recreational charter vessels; — commercial craft and workboats. It is not applicable to multihull racing craft designed only for professional racing. This document is applicable to the structures supporting windows, portlights, hatches, deadlights and doors. For the complete scantlings of the craft, this document is intended to be used in conjunction with rig attachment in sailing craft. ISO 12215-6 can be used for additional details. Throughout this document, unless otherwise specified, dimensions are in (m), areas in (m2), masses in (kg), forces in (N), moments in (Nm), Pressures in (kN/m2) (1 kN/m2 = 1 kPa), stresses and elastic modulus in (N/mm2) (1 N/mm2 = 1 MPa).

Small craft - Hull construction and scantlings - Part 7: Determination of loads for multihulls and of their local scantlings using ISO 12215-5

ISO 12215-10:2020 小艇. 船体结构和构件尺寸. 第10部分: 帆船帆装载荷和帆装附件

This document specifies methods for the determination of: — the design loads and design stresses on rig elements; and — the loads and scantlings of rig attachments and mast steps/pillars; on monohull and multihulls sailing craft. It also gives, in Annexes, "established practices" for the assessment of mast steps/pillars or chainplates NOTE 1 Other engineering methods can be used provided the design loads and design stresses are used. This document is applicable to craft with a hull length LH up to 24 m but it can also be applied to craft up to 24 m load line length. NOTE 2 The load line length is defined in the OMI "International Load Lines Convention 1966/2005", it is smaller than LH. This length also sets up, at 24 m, the lower limit of several IMO conventions. Scantlings derived from this document are primarily intended to apply to recreational craft, including charter vessels. This document is not applicable to racing craft designed only for professional racing. This document only considers the loads exerted when sailing. Any loads that may result from other situations are not considered in this document. Throughout this document, and unless otherwise specified, dimensions are in (m), areas in (m2), masses in (kg), forces in (N), moments in (N m), stresses and elastic modulus in N/mm2 (1 N / mm2 = 1 Mpa). Unless otherwise stated, the craft is assessed in fully loaded ready for use condition.

Small craft - Hull construction and scantlings - Part 10: Rig loads and rig attachment in sailing craft

ISO 21487:2012/Amd 2:2015 小艇.永久性安装的汽油和柴油燃油罐.修改件2

Small craft - Permanently installed petrol and diesel fuel tanks; Amendment 2

NF J95-036:2015 小型船舶.电气系统.交流电装置

La présente Norme Internationale définit les exigences concernant la conception, la construction et l'installation des circuits électriques à courant alternatif à basse tension fonctionnant sous des tensions nominales inférieures à 250 V en monophasé sur les petits navires de longueur de coque inférieure ou égale à 24 m.

Small craft - Electrical systems - Alternating current installations

ISO 10239:2014 小型船.液化石油气(LPG)系统

This International Standard covers the installation of permanently installed liquefied petroleum gas LPG systems and LPG burning appliances on small craft of up to 24 m length of hull. It does not cover devices used for LPG-fuelled propulsion engines or LPG-driven generators. This International Standard covers cooking appliances with internal LPG cartridges, with a capacity of It covers storage ofall LPG cylinders but is not intended to regulate the technical reduirements for such Cylinders that are Subjectto national regulations It does not contain procedures for commissioning the LPG installation. NOTE New designs, materials and methods of assembly giving at least equivalent results can be considqered to be complying with the reduirements of this International Standard when approved by a relevant body.

Small craft - Liquefied petroleum gas (LPG) systems

ISO 21487:2012/Amd 1:2014 小艇.永久性安装的汽油和柴油燃油罐.修改件1

Small craft - Permanently installed petrol and diesel fuel tanks; Amendment 1

CB/T 4369-2014 船艇用高速柴油机标定功率分级

本标准规定了船艇用高速柴油机(以下简称柴油机)标定功率分级及应用和标记要求。本标准适用于24 m以下船艇所配柴油机的功率分级与标定。其他船艇用高速柴油机可参照使用。

Classification for rated power of marine high speed diesel engine

CB/T 4372-2014 小艇 岸电系统

本标准规定了小艇上岸电系统的要求、试验方法、检验规则、标志、包装和贮存。本标准适用于从岸上电力供应系统获得单相220 V或125 V及低于此电压的、频率为50赫兹或60赫兹的交流电,长度小于24米的小艇的岸电系统的设计、制造和验收。

Small crafts.Shore power systems

EN ISO 16180:2013 小型船舶.导航灯.安装,布置和能见度

Diese Internationale Norm legt Anforderungen und Richtlinien fur Anordnung, Einbau und Tragweite von Positionslaternen fur kleine Wasserfahrzeuge mit einer Rumpflange bis 24 m fest, wie in ISO 8666 beschrieben, auf welche die COLREGs anzuwenden sind. Im Anhang A sind zusatzliche Informationen enthalten, die in das Handbuch fur Schiffsfuhrer aufgenommen werden mussen. ANMERKUNG Fur Wasserfahrzeuge auf bestimmten Gewassern bzw. Wasserstrasen konnen andere nationale Vorschriften zutreffen.

Small craft - Navigation lights - Installation, placement and visibility

BS EN ISO 10133:2012 小型船舶.电气系统.超低压直流装置

Small craft. Electrical systems. Extra-low-voltage d.c. installations

KS V ISO 10239:2013 小型船舶.液化石油气(LNG)系统

이 표준은 길이 24m 이하의 소형선박에 영구적으로 설치된 액화석유가스 장치(LPG sys

Small craft－Liquefied petroleum gas(LPG) systems