U61 船用发电、变电与配电设备 标准查询与下载

ARMY MIL-C-51212 B INT AMD 2-1987 ABC-M3型电源 顺风水蒸汽毒害计算器

This interim amendment is approved for use within .U.S. Army Chemical Research, Development and Engineering Center, Depart-ment of the Arniy, with MIL-C-51212BY dated 30 June 1967.

CALCULATOR, DOWNWIND TOXIC VAPOR HAZARD, LINE SOURCE, ABCA-M3

JIS F 8066:1986 船舶用电气装置.第303部分:设备.电力和照明用变压器

Electrical installations in ships Part 303 Equipment -- Transformers for power and lighting

JIS F 8075:1986 船舶用电气装置.第503部分:专用部件.电压范围在 1 kV 以上至最高可达(含) 11 kV 的交流供电系统

この規格は，電圧が1kVを超え11kV以下の交流配電系統に適用する。

Electrical installations in ships Part 503 Special features -- A.C. supply systems with voltages in the range above 1 kV up to and including 11 kV

CB* 373-1985 岸电箱

本标准适用于岸上供电电源直流电压250V以下，交流频率50和60Hz、电压500V以下的船用岸电箱。 本标准参照采用国际标准1EC92号出版物(船舶电气设备)201、302篇1980年版的有关规定。

Shore power box

NAVY MIL-F-29419-1985 运输结构

This specification establishes the requirements for manufacture and acceptance of the SIXCON Shipping Frame.

FRAME, SHIPPING (SIXCON)

SAE J1428-1985 海上断路器

This recommended practice covers the requirements of magnetic or thermal circuit breakers for use in marine applications for 50 V dC or less. The purpose of this recommended practice is to ensure that the specified circuit breakers will reliably provide overcurrent protection.

Marine Circuit Breakers

CB*/Z 342-1984 船用配电控制设备制造工艺

本文件作为船厂自制各类低压配电设备(包括主配电板、应急配电板、充放电板及分配电箱等)及控制设备(包括启动器、控制器、主令操纵器及集中控制台等)等电气设备的一般工艺指导性技术文件。 凡具有特殊工艺要求的电气设备的制造工艺，不包括在本文件之内，应另订专用工艺。

Manufacturing process of marine power distribution control equipment

JIS F 8829:1984 船用断路器式分电箱

Marine section boards with circuit breakers

JIS F 8830:1984 小船外用供电箱

Marine shore connection boxes (small type)

JIS F 8831:1984 船用不防水插头

Marine non-watertight type plugs

JIS F 8825:1984 船外用供电箱

Marine shore connection boxes

NAVY QPL-3954-18-1984 波导电虚载荷一般规范

This list has been prepared for use by or for the Government in the acquisition of products covered by Specification MIL-D-3954. Listing of a product is not intended to and does not connote indorsement of the product by the Department o f Defense.

DUMMY LOAD, ELECTRICAL, WAVEGUIDE GENERAL SPECIFICATION FOR

IEC 60092-351:1983 船用电气装置.第351部分:船用电力电缆的绝缘材料

Electrical installations in ships. Part 351 : Insulating materials for shipboard power cables

CB*/Z 323-1981 船用主配电板基本环节线路

Basic circuit of marine main switchboard

ARMY MIL-C-51211 B (1)-1980 ABC-M2型电源 顺风水蒸汽毒害计算器

This amendment forms a part of MilitarySpecification MIL-C-51211B(EA) dated 30 June 1967.

CALCULATOR, DOWNWIND TOXIC VAPOR HAZARD, POINT SOURCE, ABC-M2

ARMY MIL-C-51212 B (1)-1980 ABC-M3型电源 顺风水蒸汽毒害计算器

This amendment forms a part of Military Specification MIL-C-51212B(EA) dated 30 June 1967.

CALCULATOR, DOWNWIND TOXIC VAPOR HAZARD, LINE SOURCE, ABCA-M3

IEC 60092-303:1980 船舶电气设施 第303部分:设备 电力和照明变压器

Applies to all transformers used for power, lighting and static convertors and where appropriate to starting transformers, static balancers, saturable reactors and transductors for use in ships. Includes general requirements and special requirements for

Electrical installations in ships. Part 303 : Equipment - Transformers for power and lighting

NAVY MIL-P-28805 (1)-1979 电源的一般规范

This amendment forms a part of Military Specification MIL-P-28805(EC),dated 16 December 1974.

POWER SUPPLIES, GENERAL SPECIFICATION FOR

NAVY MIL-A-17367 D (1)-1978 上部未完成装甲物破碎保护(M-1955型有领)

This amendment form sapart of Military Specification MIL-A-l7367D(MC)dated 3 October 1977.

ARMOR, BODY, FRAGMENTATION PROTECTIVE: UPPER TORSO (WITH COLLAR, M-1955)

NAVY MIL-A-19879 B-1977 下部未完成装甲物破碎保护

This specification is approved for use by the Marine Corps, Department of the Navy, and is available for use by all Departments and Agencies of the Department of Defens

ARMOR, BODY, FRAGMENTATION PROTECTIVE: LOWER TORSO