U65 导航设备 标准查询与下载

BS ISO 13643-4:2017 船舶和海洋技术 船舶的操纵 停止、加速、行驶

Ships and marine technology. Manoeuvring of ships. Stopping, acceleration, traversing

BS ISO 13643-3:2017 船舶和海洋技术. 船舶的操控. 偏航稳定性和转向

Ships and marine technology. Manoeuvring of ships. Yaw stability and steering

ISO 19697:2016 船舶与海洋技术. 导航和船舶营运. 电子测斜仪

Ships and marine technology - Navigation and ship operations - Electronic inclinometers

IEC 61097-4:2016 全球海上遇险和救助系统(GMDSS).第4部分:INMARSAT-C船载地面站和INMARSAT增强群呼叫(EGC)设备.操作和性能要求、测试方法和要求的试验结果

This part of IEC 61097 specifies the performance requirements and methods of testing for Inmarsat-C ship earth stations (SES) capable of transmitting and receiving direct-printing communications, and for enhanced group call (EGC) receivers, for use in the GMDSS and for use for long-range identification and tracking (LRIT). The available variants are: Class 0: An EGC receiver, either stand-alone or an element of a GMDSS installation in accordance with the Inmarsat design and installation guidelines (DIGs) for GMDSS installations. Class 1: A basic SES providing shore-to-ship and ship-to-shore message transfer only. Class 2: As class 1 but with EGC as an alternative to shore-to-ship transfer using a shared receiver. Class 3: As class 1 but with EGC using an independent receiver. NOTE 1 The 34 th session of the IMO Sub-Committee on Radiocommunications decided that class 2 equipment would be adequate to provide sufficient availability for the reception of maritime safety information for the GMDSS. The standard complies with IMO performance requirements stated in the normative references, Inmarsat technical characteristics and test procedures, and IEC 60945 general requirements except where modifications are explicitly stated in this standard. Technical characteristics essential to GMDSS and LRIT operation as defined by the IMO are identified. All text of this standard, whose wording is identical to that in IMO SOLAS Convention 1974 as amended in 1988 and Resolutions A.807(19), MSC.263(84) and MSC.306(87) is printed in italics and reference made to the Resolution/Recommendation and subclause number. This standard covers equipment construction and testing. Matters relating to installation may also be found in the Inmarsat Maritime design and installation guidelines (see Bibliography). Those to be found in IMO Resolutions A.807(19), MSC.263(84) and MSC.306(87) are reproduced in Annex A. Responsibility for type approval of Inmarsat-C and Inmarsat-EGC is vested in Inmarsat by IMO Resolutions A.807(19) and MSC.306(87) (see 3.2.1). Therefore, this standard does not reproduce Inmarsat test procedures in full, but refers to where they are given in Inmarsat documentation cited in the normative references to this standard (Annex C). NOTE 2 For the purposes of this standard the terms Inmarsat-C, Inmarsat Standard-C, Standard-C refer to the same equipment.

Global maritime distress and safety system (GMDSS) - Part 4: Inmarsat-C ship earth station and Inmarsat enhanced group call (EGC) equipment - Operational and performance requirements, methods of testing and required test results

JIS F 9101:2015 船舶和海洋技术. 船用磁罗盘, 罗盘座和方位角读数设备

Ships and marine technology -- Marine magnetic compasses, binnacles and azimuth reading devices

DIN ISO 22090-3:2015 船舶和海洋技术.传递航向装置(THDs).第3部分:全球卫星导航系统(GNSS)原则(ISO 22090-3-2014)

Ships and marine technology - Transmitting heading devices (THDs) - Part 3: GNSS principles (ISO 22090-3:2014)

DIN ISO 22090-2:2015 船舶和海洋技术.传递航向装置(THDs).第2部分:地磁原则(ISO 22090-2-2014)

Ships and marine technology - Transmitting heading devices (THDs) - Part 2: Geomagnetic principles (ISO 22090-2:2014)

DIN ISO 22090-1:2015 船舶和海洋技术.传递航向装置(THDs).第1部分:陀螺罗盘(ISO 22090-1-2014)

Ships and marine technology - Transmitting heading devices (THDs) - Part 1: Gyro-compasses (ISO 22090-1:2014)

BS EN 62320-3:2015 海上导航和无线电通信设备及系统. 自动识别系统 (AIS). 中继站. 最低操作和性能要求. 试验方法和要求试验结果

Maritime navigation and radiocommunication equipment and systems. Automatic identification systems (AIS). Repeater stations. Minimum operational and performance requirements. Methods of test and required test results

BS ISO 22554:2015 船舶和航海技术.推进器转速指示器.电气类型和电子类型

Ships and marine technology. Propeller shaft revolution indicators. Electric type and electronic type

ISO 22554:2015 船舶和航海技术.推进器转速指示器.电气类型和电子类型

This International Standard specifies the construction, performance requirements, methods of testing, and required test results for electric and electronic propeller shaft revolution indicators (hereinafter referred to as “indicator system”) required by Clause 2.5.4, Regulation 19, chapter V,ISOLAS 1974 (as amended, 2000). This International Standard is associated with IMO Resolution A.694 (17) and IEC 60945. Where a requirement in this International Standard differs from IEC 60945, the requirement in this International Standard takes precedence. NOTE When this indicator system can be used as the tachometer for the engine of a ship, its usage as the tachometer will be accepted.

Ships and marine technology - Propeller shaft revolution indicators - Electric type and electronic type

BS EN 62288:2014 海上导航和无线电通信设备和系统.船用导航显示器的相关导航信息的表达.通用要求、试验方法和要求的试验结果

Maritime navigation and radiocommunication equipment and systems. Presentation of navigation-related information on shipborne navigational displays. General requirements, methods of testing and required test results

NF J38-140*NF EN ISO 9875:2014 船舶和海洋技术.海上回声探测设备

La présente Norme internationale spécifie les exigences minimales de fonctionnement et de performances, les méthodes d'essai et les résultats d'essais des appareils marins de sondage par écho, exigés pour se conformer aux standards de performance adoptés par la Résolution A.224(VII) de l'OMI. De plus, elle tient compte de la Résolution A.694(17) de l'OMI, et elle est associée à l'IEC 60945.

Ships and marine technology - Marine echo-sounding equipment

ISO 8728:2014 船舶与海上技术.船用陀螺罗经

This International Standard specifies the construction, performance, and type testing for gyro-compasses required by Regulation 12 of Chapter V ofISOLAS 1974 (as amended). NOTE All requirements that are extracted from the recommendations of IMO Resolutions [Resolution A.424(XI) on performance standards for gyro-compasses] are printed in italics. Clause or sub-clause in ISO 87286.1, 8a 349.27.17.29.79.36.26.39.4 - 5.15.1.15.1.25.2.15.2.25.2.3.15.2.3.25.2.3.35.2.3.45.2.47.3, 9.6 Table B.1 Clause or sub-clause in ISO 87288 Information Annex A a Slight differences in text. Clause or sub-clause in IMO Resolution A. 424 (XI) [Performance standards for gyro compasses] 9.59.1a 13 Bibliography [1] IEC 61162-3, Maritime navigation and radiocommunication equipment and systems — Digital interfaces — Part 3: Serial data instrument network [3] IEC 62288, Maritime navigation and radiocommunication equipment and systems — Presentation of navigation-related information on shipborne navigational displays — General requirements, methods of testing and required test results [2] [4] [5] [6] IEC 61162-450, Maritime navigation and radiocommunication equipment and systems — Digital interfaces — Part 450: Multiple talkers and multiple listeners — Ethernet interconnection IMO Resolution A.424(XI), Performance standards for gyro-compasses IMO Resolution A.694(17), General requirements for shipborne radio equipment forming part of the global maritime distress and safety system (GMDSS) and for electronic navigational aids International Convention for the Safety of Life at Sea ISOLAS) 1974 (amended) 14 ICS 47.020.70 Price based on 14 pages 

Ships and marine technology - Marine gyro-compasses

BS ISO 8728:2014 船舶和航海技术.航海陀螺罗盘

Ships and marine technology. Marine gyro-compasses

IEC 62288:2014 海上导航和无线电通信设备和系统.船用导航显示器的关于导航信息的显示.通用要求、测试 方法和要求的试验结果

This International Standard specifies the general requirements@ methods of testing@ and required test results@ for the presentation of navigation-related information on shipborne navigational displays in support of IMO resolutions MSC.191(79) and MSC.302(87).

Maritime navigation and radiocommunication equipment and systems - Presentation of navigation-related information on shipborne navigational displays - General requirements, methods of testing and required test results

BS EN 62065:2014 船舶导航和无线电通信设备和系统.跟踪控制系统.测试方法和要求的试验结果操作和性能要求

Maritime navigation and radiocommunication equipment and systems. Track control systems. Operational and performance requirements, methods of testing and required test results

CB/T 3693-2014 船用电磁摆

本标准规定了船用电磁摆(以下简称电磁摆)的要求、试验方法、检验规则、标志、包装与贮存。本标准适用于电磁摆的设计、制造和验收,也适用于其他用途陀螺罗经用电磁摆。

Marine electromagnetic pendulum

BS ISO 22090-1:2014 船舶和海洋技术. 传递航向装置 (THD). 陀螺罗盘

Ships and marine technology. Transmitting heading devices (THDs). Gyro-compasses

BS ISO 22090-2:2014 船舶与海洋技术. 传递航向装置(THD). 地磁原理

Ships and marine technology. Transmitting heading devices (THDs). Geomagnetic principles