V52 货运 标准查询与下载

SAE AIR806B-1997 飞机货运的空气调节

The report presents air conditioning data for aircraft cargo which is affected by temperature, humidity, ventilation rate and atmospheric pressure. The major emphasis is on conditioning of perishable products and warm-blooded animals. The report also covers topics peculiar to cargo aircraft or which are related to the handling of cargo. The purpose of this Aerospace Information Report (AIR) is to provide design information related to the air conditioning of cargo transported by commercial and military aircraft. Affected cargo includes perishable products, live animals and hazardous materials.

Air Conditioning of Aircraft Cargo

SAE AIR4359-1997 悬重(如挂衣箱)对集装箱性能的影响

This SAE Aerospace Information Report (AIR) provides information on the subject of Air Mode containers used for transporting Hanging Loads such as Garment-On-Hangers (GOH), or other roof supported cargo. It suggests considerations and recommendations for roof loaded containers to transport hanging loads efficiently and safely by air and to protect the aircraft floor and cargo system from damage due to overload conditions.

Effects of Hanging Loads (e.g., GOH) on ULD Performance

AIR FORCE MIL-P-83037 A NOTICE 1-1997 A/E29H-1空中运载货运平台

MIL-P-83037A (USAF) is inactive for new design and is no longer used, except for replacement purposes. Custodians:

PLATFORM, CARGO, AERIAL DELIVERY A/E29H-1

AIR FORCE MIL-PRF-83323 B-1997 空中加油普遍贮器试验机

This specification covers a type of universal aerial refueling receptacle ground tester (UARRGT) to be used in lünctionally testing receiver aircraft using the boom-receptacle method of aerial refueling.

TESTER, UNIVERSAL RECEPTACLE, AERIAL REFUELING

AIR FORCE MS27761 REV A NOTICE 1-1997 刀的发行与货运平台

This notice should be filed in front of MS27761 Rev A, dated 9 August 1974

KNIFE, RELEASE, CARGO PLATFORM

HB 7465-1996 飞机空运集装板网通用规范

本标准规定了飞机空运集装板网（以下简称集装板网）的技术要求、试验方法、检验规则、标志、包装与贮存。 　　本标准适用于GB/T　15140　Ⅱ级限动系统的飞机空运集装板网的设计、制造、试验及验收，并与HB　7223飞机空运集装板配套使用。

General specification for pallet netting for aircraft air transport

SAE ARP1621B-1996 运输马匹的飞机集装箱

This SAE Aerospace Recommended Practice (ARP) defines minimum requirements for an aircraft transport ULD to transport horses properly and safely by air, to protect the horse(s) from injuries, and to protect the aircraft from corrosion created by waste spill. The ULD is designed to accommodate one horse or several.

ULD for Aircraft Transportation of Horses

ISO 11242:1996 航空器 货运集装箱压力均衡要求

Describes the minimum safety requirements to be met by containers used to transport cargo by civil transport aircraft under normal pressure equalization during climb and descent and under emergency pressure equalization in the event of a sudden depressurization.

Aircraft - Pressure equalization requirements for cargo containers

SAE AS1560A-1996 公制支柱和螺旋齿轮的模块和基础货架

This SAE Aerospace Standard (AS) establishes the standard modules for aerospace metric involute gear teeth and establishes the tooth dimensions of aerospace metric involute gear teeth in terms of the conjugate rack type cutter whose counterpart reference profile is called the basic rack profile of the generated gear, having the tooth dimensions expressed in terms proportional to the module.

Modules and Basic Racks of Metric Spur and Helical Gears

AIR FORCE MIL-P-87133 NOTICE 1-1996 PLU-6/C型(空中导航)战斗任务绘图器

This notice should be filed in fiont of MIL-P-87133, dated 2 May 1978

PLOTTER, COMBAT MISSION, PLU-6/C, (AIR NAVIGATION)

GOST ISO 4118-1996 航空运输用未经认证的底舱集装箱.一般技术要求和测试方法

Стандарт устанавливает технические требования и методы испытаний авиационных нижнепалубных контейнеров, не требующих сертификации летн

Non-certified lower-deck containers for air transport. General technical requirements and test methods

GOST ISO 4115-1996 航空/陆地运输托盘网.一般技术要求

Стандарт распространяется на сетки для удержания грузов на авиационно-наземных поддонах шириной 2438 мм

Air/land pallet nets. General technical requirements

BS M 85:1995 航空货运设备 具有 22250 N（5000lbf）或以上全向额定负载能力的双螺柱系紧配件的标识

This International Standard specifies an identification scheme for double-stud tie-down fittings having an omnidirectional rated load capacity of 22 250 N (5 000 Ibf) or above in a rail conforming to ISO 7166. It is applicable to all cargo tie-down fittings equipped with a moveable plunger, regardless of material or method of fabrication, that satisfy national regulatory airworthiness requirements with regard to the ad-ditional special factors appropriate to the method of fabrication of the assembly or component parts thereof. The requirements specified in this International Stan-dard are intended to facilitate identification of such tie-down fittings by non-technical ramp and cargo personnel.

Air cargo equipment. Identification of double-stud tie-down fittings having an omnidirectional rated load capacity of 22 250 N (5 000 lbf) or above

BS M 84:1995 航空货运设备.航空货运用合格的飞机集装箱.规范和试验

This International Standard specifies the basic re-quirements for the specification and testing of con-tainers that have the nominal base sizes shown in table 1. It provides minimum requirements for a certified air-craft container not exclusively designed for lower deck and wide body aircraft.

Air cargo equipment - Certified aircraft container for air cargo - Specification and testing

ISO 8097:1995 航空器.经认证的航空成组装运设备的最低飞行性能要求和试验条件

Aircraft - Minimum airworthiness requirements and test conditions for certified air cargo unit load devices

AIR FORCE MIL-T-9720 F NOTICE 1-1995 MJ-1A 与 MJ-1B型3000磅容量空中商店起重机车

This notice should be filed in fiont of MIL-T-9720F(USAF) dated 23 July 1984.

TRUCK, LIFT, AERIAL STORES, 3000 POUNDS CAPACITY MJ-1A AND MJ-1B

BS M 82:1995 航空货运设备 行间托盘网

This International Standard specifies dimensional, structural and environmental requirements for nets used to secure cargo on aircraft pallets meeting the requirements of ISO 4117 or ISO 4171. This International Standard establishes six basic sizes of pallet nets, as given in table 1.

Air cargo equipment. Interline pallet nets

BS M 80:1995 航空货运设备.宽体飞机主层舱集装箱/托盘装载机.功能要求

This International Standard specifies the functional requirements for a self-propelled loader capable of raising pallets and containers with base dimensions and maximum weights as follows: This International Standard shall be read in conjunc-tion with ISO 4116. For further information, see IATA Specification AHM 932, Functional specification for main deck container/pallet loader. note:1) The term "weight" is used in this International Standard instead of the correct technical term "mass", in order to conform to current commercial usage. 2) AHM 932 is part of the IATA Airport Handling Manual, which is available from: IATA Publications Dept, 2000 Peel Street, Montreal, Quebec H3A 2R4, Canada, or: IATA Publications Dept., Route de I'Aeroport 33, PO Box 672, CH-1215 Geneva 15 Airport, Switzerland.

Air cargo equipment - Wide body aircraft main deck container/pallet loader - Functional requirements

HB 7076-1994 直升机机载外挂物吊耳

本标准适用于承载5000N和10000～25000N直升机机载外挂物吊耳。

Helicopter on-board external storage lug

HB 7077-1994 舰载直升机系留设计要求

本标准规定了舰载直升机的系留连接点和与系留有关的直升机承力结构的设计与构造要求。 　　本标准适用于舰载直升机的系留设计。

Design requirements for shipboard helicopter mooring