W21 毛半制品 标准查询与下载

NAVY MIL-DTL-29451 B-1997 聚酯或羊毛中等重量女士夹克

This specification covers requirements for a male lightweight jacket.

JACKET, MEN'S - INTERMEDIATE WEIGHT, POLYESTER/WOOL

DLA A-A-55314-1997 正反两面穿逆羊毛衫

This commercial item description covers the requirements for a reversible jersey in two (2) types. The jersey is intended for use by personnel of the Department of Defense.

JERSEY, REVERSIBLE

FZ/T 01046-1996 兔毛产品掉毛量的测定

本标准规定了测定兔毛产品掉毛量的方法。 本标准适用于含兔毛纤维的纱线、织物。

Determination of shedding amount of rabbit fur products

DLA A-A-55239 A-1996 羊毛外套

This commercial item description covers the requirements for a service wool sweater intended for use by personnel of the US Marine Corps.

SWEATER, SERVICE, WOOL

DLA A-A-55226 A-1996 头戴羊毛围巾和脖颈丝巾[取代:军事MIL-S-29428 A,NAVY MIL-S-29428]

This commercial item description covers the requirements for knitted wool scarfs intended for use by personnel of the Department of Defense.

SCARF, NECKWEAR, WOOL AND SCARF, HEADOVER, WOOL [Superseded: NAVY MIL-S-29428 A, NAVY MIL-S-29428]

DLA A-A-55302-1996 羊毛和棉冬袜

The General Services Administration has authorized the use of this commercial item description as a replacement for Military Specifications MIL-V-16720E and MIL-V-16721D which are cancelled.

SOCKS, WINTER (WOOL AND COTTON)

ASTM D2252-96 各类阿尔帕卡毛细度的标准规范

1.1 This specification is applicable in the classification of alpaca into types according to fineness. 1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.3 The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are provided for information only.

Standard Specification for Fineness of Types of Alpaca

ASTM D2118-96 羊毛及其制品中标准水份含量的确定

1.1 This practice recommends that a single value be adopted for the commercial moisture content of wool in any of the following forms: 1.1.1 Scoured, 1.1.2 Carbonized and neutralized, 1.1.3 Noils, uncarbonized, 1.1.4 Top, oil or dry combed, 1.1.5 Yarn, worsted, 1.1.6 Yarn, woolen, 1.1.7 Yarn, hand knitting, or 1.1.8 Fabric. 1.2 Limitations -Grease wool, pulled wool, and wool with pH below 5.0 are excluded from this practice. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Assigning a Standard Commercial Moisture Content for Wool and its'' Products

FZ/T 21002-1995 国产细羊毛及其改良毛洗净毛

本标准规定了国产细羊毛及其改良毛洗净毛的分等规定、技术条件、试验方法、验收规则和包装标志。 本标准适用于鉴定国产细羊毛及其改良毛洗净的品质。

Domestic fine wool and its improved wool scoured wool

DLA A-A-55188 A-1995 防皱和防虫羊毛床单绒被

This commercial item description covers wool blankets.

BLANKETS, BED, WOOL, SHRINK RESISTANT AND MOTHPROOFED

ASTM D2524-95(2003) 毛纤维抗断裂强度的试验方法.平列纤维束法.1/8英寸(3.2毫米)规范长度的标准试验方法

Test Method D 2524 for testing wool fibers for tenacity is considered satisfactory for acceptance testing when the participating laboratories, using a reference wool, have shown acceptable between-laboratory precision. It is recommended that any program of acceptance testing be preceded by an interlaboratory check in the laboratory of the purchaser and the laboratory of the seller on replicate specimens of samples of the material to be evaluated. In cases of dispute, the statistical bias, if any, between the laboratory of the purchaser and the seller should be determined with each comparison being based on testing randomized specimens from one sample of material of the type being evaluated. Values obtained from flat bundle tenacity show a good correlation with values obtained from single fiber tests and require much less time. The basic differences between the procedures described in Test Method D 2524 and those described in Test Method D 1294 lie in the manner of clamping the bundles and the shorter gage length employed. The special clamps used in this method allow quicker and easier bundle preparation; however, for Test Method D 1294 no special clamps are required. Closer agreement with single fiber tenacity is also obtained with Test Method D 2524 than when using the procedure in Test Method D 1294. As the observed tenacity of fibers depends in part on the type of tensile testing machine used and the time required to break the specimen, results obtained with the different types of machines which may be used in this method will not necessarily agree. The machines specifically designed for bundle testing are CRL testers which operate at a loading rate of 1 kgf/s and therefore reach the breaking force at variable times in the order of 5 s. CRE and CRT type machines would be expected to produce somewhat different results not only because of the inherent difference in operation but because CRE and CRT type machines are to be operated at a rate to achieve the breaking load in 20 s.1.1 This test method covers the determination of the breaking tenacity of wool fibers as a flat bundle with a 1/8-in. (3.2-mm) clamp separation.1.2 This test method is especially adapted to the fiber bundle clamps and strength testing instruments specified, but may be used on other tensile testing machines when equipped with appropriate adapters to accommodate the prescribed clamps.1.3 This test method is applicable to wool in any form which can be hand-combed into small bundles of parallelized fibers. Note 18212;Other test methods for measuring breaking tenacity of fiber bundles include Test Methods D 1294, D 1445, and D 540.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are provided for information only.

Standard Test Method for Breaking Tenacity of Wool Fibers, Flat Bundle Method- 1/8-in. (3.2-mm) Gage Length

ASTM D1770-94(2006) 羊毛条中毛结,植物性物质与有色纤维含量标准测试方法

Test Method D 1770 for the determination of neps, vegetable matter, and colored fiber may be used for the acceptance testing of commercial shipments of wool top but caution is advised because the between-laboratory precision is known to be poor. Comparative tests as directed in 5.1.1 may be advisable. 5.1.1 In case of a dispute arising from differences in reported test results when using Test Method D 1770 for acceptance testing of commercial shipments, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens that are as homogeneous as possible and that are from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using Studentrsquo;t-test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results in the light of the known bias.1.1 This test method covers the determination of the number of neps and pieces of vegetable matter by size classes, and the number of colored fibers, in 15 g samples of wool top.1.2 This test method is applicable to wool top in any form. Note 1 - For the determination of number of neps per specified mass of cotton samples, refer to Test Method D 1446.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Neps, Vegetable Matter, and Colored Fiber in Wool Top

ASTM D3991-94(2006) 羊毛和马海毛细度及分级的标准规范

1.1 These specifications cover the classification, by fineness grade, of wool or mohair that is in the grease, pulled, washed, or scoured state, or in the form of card sliver.1.2 These specifications are applicable also to assignment of grade for wool or mohair in spun materials or products processed beyond carding on the woolen system but not on the worsted system which involves a combing process.Note 1 - For fineness specifications for wool top, mohair top, and alpaca, refer to Specifications D 3992 and D 2252.

Standard Specifications for Fineness of Wool or Mohair and Assignment of Grade

ASTM D2165-94(2006) 羊毛及类似动物纤维的水萃取物pH值的标准测试方法

The pH values of the extracts give an indication of the acidity or alkalinity of the fiber and its water-soluble impurities. These values are useful in indicating previous processing and in anticipating subsequent performance. For particular purposes, the pH of an extract prepared by one method may be a more informative index than another and as a consequence four optional extraction procedures are included. This test method is not recommended for acceptance testing because the between-laboratory precision is relatively poor. In some cases, the purchaser and the seller may have to test a commercial shipment of one or more specific materials by the best available method, even though the method has not been recommended for acceptance testing of commercial shipments. In such a case, if there is disagreement arising from differences in values reported by the purchaser and the seller when using this method for acceptance testing, the statistical bias, if any, between the laboratory of the purchaser and the laboratory of the seller should be determined, with each comparison being based on testing specimens randomly drawn from one sample of material of the type being evaluated.1.1 This test method covers the determination of the pH of aqueous extracts from wool and similar animal fibers. It is applicable to fibers in any condition-raw wool, scoured wool, sliver, top, yarn, or fabric.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 11.

Standard Test Method for pH of Aqueous Extracts of Wool and Similar Animal Fibers

ASTM D3992-94(2006) 羊毛条和马海毛条细度及分级的标准规范

1.1 These specifications are applicable in the classification, by fineness grade, of the fiber in wool top, mohair top, wool yarns, mohair yarns, wool fabrics, and mohair fabrics of the worsted type. Note 1 - For fineness specifications for wool, mohair, and alpaca, refer to Specifications D 3991 and D 2252.

Standard Specifications for Fineness of Wool Top or Mohair Top and Assignment of Grade

ASTM D2720-94(2006) 商业用各种洗净羊毛、毛条及短毛的商业公定重量和产量计算的标准实施规程

1.1 This practice includes, in , the commercial composition corresponding to different commercial designations for scoured wool, wool top, and wool noil, all of which contain, in addition to wool base, various percentages of moisture, material extractable with alcohol, and mineral matter.1.2 This practice includes directions for the calculation of the commercial weight of wool corresponding to different commercial designations for several forms of wool, and for converting the commercial weight (mass) calculated on one basis to the commercial weight calculated on a different basis.1.3 This practice also includes directions for calculating the yield, on various commercial designation bases, obtained by processing raw wool, and for converting the yield calculated on one commercial designation basis to the yield on another commercial designation basis. Note 1 - Because of trade practice the term "weight" is used in this practice instead of the technically correct term "mass".This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Calculation of Commercial Weight and Yield of Scoured Wool, Top, and Noil for Various Commercial Compositions

DLA A-A-55212-1993 女式羊毛带

The General Services Administration has authorized the use of this Commercial Item Description in preference to MIL-B-29408.

BELT, ALL-WEATHER COAT, WOMEN'S

DLA A-A-55211-1993 羊毛纱

The General Services Administration has authorized the use of this Commercial Item Description in preference to MIL-Y-16654.

YARN, WOOL

FZ/T 21001-1993 自梳外毛毛条

本标准规定了自梳外毛毛条的技术要求，验收要求、包装和标志。 本标准为全国毛纺工业鉴定自梳外毛毛条（澳大利亚、新西兰进口羊毛）的品质和交货验收之统一规定。

Self combing tops

DLA MIL-C-19516 G (1)-1992 男式蓝色华达呢涤纶/羊毛

This amendment forms a part of Military Specification MIL-C-19516G(MC), dated 6 March 1991, and is available for use by all Departments and Agencies of the Department of Defense.

COAT, MAN'S: POLYESTER/WOOL, GABARDINE; BLUE