共找到 690 条与 毯类 相关的标准,共 46 页
Resilient, textile and laminate floor coverings. Environmental product declarations. Product category rules
This document specifies a method to determine the susceptibility of textile floor coverings to mechanical damage at cut edges. It is applicable to all textile floor coverings both as sheet materials and as tiles.
Textile floor coverings - Determination of resistance to damage at cut edges using the modified Vettermann drum test
Code of practice for installation of resilient floor coverings
Textile floor coverings. Consumer information
Textile floor coverings - Consumer information
5.1 This test method may be used to soil test specimens in the absence of abrasive wear and texture changes under controlled conditions using a standard synthetic soil, or as a preliminary step to other procedures. 5.2 This test method will provide a uniformly soiled test specimen to evaluate, is reproducible (see section 11), and is economical for Testing Laboratories. 5.3 This test method has been found to give results similar to the actual floor service soiling, but its use is recommended only as a screening test method and not as a replacement for floor testing. 5.4 The acceptance criteria of this test method shall be set by mutual agreement between the purchaser and supplier. 1.1 This test method describes the equipment, and the test method for assessing the propensity of pile yarn floor coverings to soiling in the absence of abrasive wear and texture changes, using a standard synthetic soil composition. 1.2 This test method is applicable for use in testing unused pile yarn floor covering of all types. It is not applicable for use in testing used pile yarn floor covering. 1.3 This test method can be used to compare the soiling propensity of two or more carpets; or it can be used to soil carpets as a preliminary step to other test procedures. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Accelerated Soiling of Pile Yarn Floor Covering
5.1 Test Method D1335 for tuft bind of pile yarn floor coverings is being used for acceptance testing of commercial shipments. Comparative tests as directed in 5.1.1 may be advisable. 5.1.1 In case of a dispute arising from differences in reported test results using this test method, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended from the investigation of bias. As a minimum, the two parties should take a group of test samples that are homogeneous as possible and are from a lot of material of the type in question. The test samples should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using appropriate statistical analysis, and a probability level chosen by the two parties before testing begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results with consideration to the known bias. 5.2 The satisfactory performance of a pile yarn floor covering depends to a considerable extent on the maintenance of its original appearance. In a cut pile yarn floor covering an inadequate tuft bind may result in complete loss of pile in areas exposed to severe wear. In a looped pile yarn floor covering with inadequate tuft bind the pile loops may be pulled out to form unsightly long loops which may be hazardous. 1.1 This test method covers the measurement of force required to pull or break a tuft from a pile floor covering sample. 1.2 This test method is applicable to both cut and loop pile yarn floor covering. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Standard Test Method for Tuft Bind of Pile Yarn Floor Coverings
Textile floor coverings - Water impermeability test
Resilient floor coverings - Specification for floor panels/assembly for loose laying
Resilient and laminate floor coverings - Assessment of static electrical propensity; German version EN 1815:2016
Textile floor coverings - Blade test - Flocked textile floor covering
Resilient and laminate floor coverings. Assessment of static electrical propensity
Laminate floor coverings - Elements with acrylic based surface layer, electron beam cured - Specifications, requirements and test methods; German version EN 14978:2016
Standard Test Method for Ignition Characteristics of Finished Textile Floor Covering Materials
Textile floor coverings - Classification; German version EN 1307:2014+A1:2016
Resilient floor coverings. Heterogeneous polyurethane floor coverings. Specification
Textile floor coverings - Colour fastness to shampooing
Resilient, textile and laminate floor coverings - Castor chair test
Resilient, textile and laminate floor coverings. Floor covering standard symbols. Complementary element
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号