Z11 气体介质与放射性物质采样方法 标准查询与下载

NF T90-370:1999 水质.取样.第16部分:样本生物试验指南

Water quality. Sampling. Part 16 : guidance on biotesting of samples.

BOCA CHAPTER 34 NFPC-1999 液态和固态高毒和有毒物质

The following is a listing of the standards referenced in this code, the effective date of the standard, the promulgating agency of the standard and the section(s) of this code that refer to the standard.

Liquid and Solid Highly Toxic and Toxic Materials

ASTM D5111-99(2006) 非都市地区监测大气沉积物的选址和取样方法的标准指南

The guide consolidates into one document, siting criteria and sampling strategies used routinely in various North American atmospheric deposition monitoring programs. The guide leads the user through the steps of site selection, sampling frequency and sampling equipment selection, and presents quality assurance techniques and other considerations necessary to obtain a representative deposition sample for subsequent chemical analysis. The guide extends Practice D 1357 to include specific guidelines for sampling atmospheric deposition including acidic deposition.1.1 This guide assists individuals or agencies in identifying suitable locations and choosing appropriate sampling strategies for monitoring atmospheric deposition at non-urban locations. It does not purport to discuss all aspects of designing atmospheric deposition monitoring networks.1.2 The guide is suitable for use in obtaining estimates of the dominant inorganic constituents and trace metals found in acidic deposition. It addresses both wet and dry deposition and includes cloud water, fog and snow.1.3 The guide is best used to determine estimates of atmospheric deposition in non-urban areas although many of the sampling methods presented can be applied to urban environments.

Standard Guide for Choosing Locations and Sampling Methods to Monitor Atmospheric Deposition at Non-Urban Locations

ASTM D5111-99 非都市地区监测大气沉积物的选址和取样方法的标准指南

1.1 This guide assists individuals or agencies in identifying suitable locations and choosing appropriate sampling strategies for monitoring atmospheric deposition at non-urban locations. It does not purport to discuss all aspects of designing atmospheric deposition monitoring networks. 1.2 The guide is suitable for use in obtaining estimates of the dominant inorganic constituents and trace metals found in acidic deposition. It addresses both wet and dry deposition and includes cloud water, fog and snow. 1.3 The guide is best used to determine estimates of atmospheric deposition in non-urban areas although many of the sampling methods presented can be applied to urban environments.

Standard Guide for Choosing Locations and Sampling Methods to Monitor Atmospheric Deposition at Non-Urban Locations

BS ISO 6768:1998 周围空气.二氧化氮含量浓度的测定.改进的格里斯-萨尔茨曼(Griess-Saltzman)方法

Applicable within the range 0,003 to about 2 mg/m3 with a sampling period from 10 min to 2 h.

Ambient air - Determination of mass concentration of nitrogen dioxide - Modified Griess-Saltzman method

HJ/T 22-1998 气载放射性物质取样一般规定

本标准规定了核设施中气载放射性物质的取样原则以及对取样方法与设备的一般要求。 本标准适用于实施气载放射性物质监测的各类工作场所、管道和烟囱以及大气环境的空气取样。

General rules for sampling airborne radioactive materials

HJ/T 21-1998 核设施水质监测采样规定

本标准规定了监测核设施地下水、地表水（不包含海水）、工艺排放水的采样要求。 本标准适用于核设施和操作放射性物质的各单位。

Sampling requirments for waterquality monitoring in nuclear facilities

ASTM D1739-98(2010) 降尘(可沉降粒状物)的收集和测量的标准试验方法

This test method has the advantage of extreme simplicity. It is a crude and non-specific test method, but it is useful in the study of long-term trends. It requires very little investment in equipment and can be carried out without a large technically-skilled staff. This test method is useful for obtaining samples of settleable particulate matter for further chemical analysis (1) . 1.1 This test method covers a procedure for collection of dustfall and its measurement. This test method is not appropriate for determination of the dustfall rate in small areas affected by specific sources. This test method describes determination of both water-soluble and insoluble particulate matter. 1.2 This test method is inappropriate for industrial hygiene use except where other more specific methods are also used. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Collection and Measurement of Dustfall (Settleable Particulate Matter)

ASTM D1739-98(2004) 降尘(可沉降粒状物)的收集和测量的试验方法

This test method has the advantage of extreme simplicity. It is a crude and non-specific test method, but it is useful in the study of long-term trends. It requires very little investment in equipment and can be carried out without a large technically-skilled staff. This test method is useful for obtaining samples of settleable particulate matter for further chemical analysis (1)5 . 1.1 This test method covers a procedure for collection of dustfall and its measurement. This test method is not appropriate for determination of the dustfall rate in small areas affected by specific sources. This test method describes determination of both water-soluble and insoluble particulate matter. 1.2 This test method is inappropriate for industrial hygiene use except where other more specific methods are also used. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Collection and Measurement of Dustfall (Settleable Particulate Matter)

ASTM D1739-98 降尘(可沉降粒状物)的收集和测量的试验方法

1.1 This test method covers a procedure for collection of dustfall and its measurement. This test method is not appropriate for determination of the dustfall rate in small areas affected by specific sources. This test method describes determination of both water-soluble and -insoluble particulate matter. 1.2 This test method is inappropriate for industrial hygiene use except where other more specific methods are also used. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Collection and Measurement of Dustfall (Settleable Particulate Matter)

ASTM D1739-98(2017) 落尘(沉降颗粒物)的收集和测量的标准试验方法

5.1 This test method has the advantage of extreme simplicity. It is a crude and non-specific test method, but it is useful in the study of long-term trends. It requires very little investment in equipment and can be carried out without a large technically-skilled staff. 5.2 This test method is useful for obtaining samples of settleable particulate matter for further chemical analysis (1).4 1.1 This test method covers a procedure for collection of dustfall and its measurement. This test method is not appropriate for determination of the dustfall rate in small areas affected by specific sources. This test method describes determination of both water-soluble and insoluble particulate matter. 1.2 This test method is inappropriate for industrial hygiene use except where other more specific methods are also used. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Test Method for Collection and Measurement of Dustfall (Settleable Particulate Matter)

ASTM D4597-97 用固体吸附剂扩散采样器从工作地点大气中采集有机气体或蒸气的标准实施规程

1.1 This practice covers the sampling of workplace atmospheres for the presence of certain vapors or gases by means of diffusion across a specified quiescent region and subsequent adsorption on a solid sorbent.

Standard Practice for Sampling Workplace Atmospheres to Collect Gases or Vapors with Solid Sorbent Diffusive Samplers

BOCA CHAPTER 34 NFPC-1996 液态和固态高毒和有毒物质

The fire prevention code official shall recommend to the chief administrative official of the municipality the location or relocation of new or existing fire hydrants and the placement or replacement of inadequate water mains located upon public prope

Liquid and Solid Highly Toxic and Toxic Materials

NF X43-104:1995 空气质量.有气味的气体.取样方法

Air quality. Odoring atmospheres. Sampling methods.

NF X43-294:1995 工作场所空气.多环芳香碳氢化合物的取样和分析

Workplace air. Sampling and analysis of the polycyclic aromatic hydrocarbons.

ISO 10312:1995 环境空气 石棉纤维的测定 直接传递电子显微镜法

Specifies a reference method using transmission electron microscopy for the determination of the concentration of asbestos structures in ambient atmospheres and includes measurement of the lengths, widths and aspect ratios of the asbestos structures. The method allows determination of the types of asbestos fibres present. The method cannot discriminate between individual fibres of the asbestos and non-asbestos analogues of the same amphibole mineral.

Ambient air - Determination of asbestos fibres - Direct-transfer transmission electron microscopy method

ASTM D3686-95 进行大气取样以收集有机化合物蒸气的标准实施规范(活性碳管吸附法)

1.1 This practice covers a method for the sampling of atmospheres for determining the presence of certain organic vapors by means of adsorption on activated charcoal using a charcoal tube and a small portable sampling pump worn by a worker. A list of some of the organic chemical vapors that can be sampled by this practice is provided in Annex 1. This list is presented as a guide and should not be considered as absolute or complete.1.2 This practice does not cover any method of sampling that requires special impregnation of activated charcoal or other adsorption media.1.3 The values stated in SI units are to be regarded as the standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific safety precaution is given in .

Standard Practice for Sampling Atmospheres to Collect Organic Compound Vapors (Activated Charcoal Tube Adsorption Method)

ASTM D1357-95(2011) 规划环境大气取样点的标准操作规程

Since the analysis of the atmosphere is influenced by phenomena in which all factors except the method of sampling and analytical procedure are beyond the control of the investigator, statistical consideration must be given to determine the adequacy of the number of samples obtained, the length of time that the sampling program is carried out, and the number of sites sampled. The purpose of the sampling and the characteristics of the contaminant to be measured will have an influence in determining this adequacy. Regular, or if possible, continuous measurements of the contaminant with simultaneous pertinent meteorological observations should be obtained during all seasons of the year. Statistical techniques may then be applied to determine the influence of the meteorological variables on the concentrations measured (2). Statistical methods may be used for the interpretation of all of the data available (2). Trends of patterns and relationships between variables of statistical significance may be detected. Much of the validity of the results will depend, however, on the comprehensiveness of the analysis and the location and contaminant measured. For example, if 24-h samples of suspended particulate matter are obtained only periodically (for example, every 6 or 8 days throughout the year), the geometric mean of the measured concentrations is representative of the median value assuming the data are log normally distributed. The geometric mean level may be used to compare the air quality at different locations at which such regular but intermittent observations of suspended particulate matter are made.1.1 The purpose of this practice is to present the broad concepts of sampling the ambient air for the concentrations of contaminants. Detailed procedures are not discussed. General principles in planning a sampling program are given including guidelines for the selection of sites and the location of the air sampling inlet. 1.2 Investigations of atmospheric contaminants involve the study of a heterogeneous mass under uncontrolled conditions. Interpretation of the data derived from the air sampling program must often be based on the statistical theory of probability. Extreme care must be observed to obtain measurements over a sufficient length of time to obtain results that may be considered representative. 1.3 The variables that may affect the contaminant concentrations are the atmospheric stability (temperature-height profile), turbulence, wind speed and direction, solar radiation, precipitation, topography, emission rates, chemical reaction rates for their formation and decomposition, and the physical and chemical properties of the contaminant. To obtain concentrations of gaseous contaminants in terms of weight per unit volume, the ambient temperature and atmospheric pressure at the location sampled must be known. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Planning the Sampling of the Ambient Atmosphere

BOCA CHAPTER 34 NFPC COMM-1993 高毒和有毒固体和液体

A person shall not willfully fail or refuse to comply with any lawful order or direction of the fire prevention code officiai or to interfere with the compliance attempts of another individual.

Highly Toxic and Toxic Solids and Liquids

BOCA CHAPTER 34 NFPC-1993 高毒和有毒固体和液体

To serve governmental units, code administration personnel, and related building industry professionals by providing authoritative technical, educational and informational services relating to all specialty mas of code administration and enforcement.

Highly Toxic and Toxic Solids and Liquids