EN 60512-23-3:2019
电气设备用机电元件.基本试验过程和测量方法.第23-3部分:试验23c:插头和加速器的密封效果

Connectors for electrical and electronic equipment - Tests and measurements - Part 23-3: Screening and filtering tests - Test 23c: Shielding effectiveness of connectors and accessories - Line injection method

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 EN 60512-23-3:2019 前三页，或者稍后再访问。

如果您需要购买此标准的全文，请联系： 。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

EN 60512-23-3:2019

发布

2019年

发布单位

CENELEC - European Committee for Electrotechnical Standardization

当前最新

EN 60512-23-3:2019

 

 

适用范围

This part of IEC 60512 defines a standard test method for measuring the shielding effectiveness SE of a shielded connector@ or of a connector not provided with integral shield once fitted with a shielding accessory and terminated with a screened cable. The complete assembly has a continuous 360??hielding capability throughout its length. NOTE 1 Practically@ continuous 360??hielding is not always achievable based on the geometry of the connector. NOTE 2 Shielding?? is used in this document with the same meaning as ??screening??. This test method can be applied to shielded connectors and to connector accessories with shielding capability. The following different connector designs can be tested: ?C circular connectors; ?C rectangular connectors; ?C connectors for printed boards; ?C connector shielding accessories. NOTE 3 For the definition of ??accessory?? see IEV 581-24-10. A shielding accessory i.e. an accessory that confers shielding to a non-inherently shielded connector@ may be a suitable set of shielded housings providing electrical continuity@ along the mated connector set@ between the screen of the (screened) cable at the cable outlet of the free cable connector housing and the metallic mounting surface for the fixed connector housing. The free connector housing is provided with a cable screen clamp. This test method utilizes the principle that the intrinsic shielding property of the connector/ accessory/cable assembly is its surface transfer impedance ZT which can be expressed as the longitudinal voltage inside the shield@ relative to the current flow on the outside shell. This test method is based on two impedance-matched circuits. See Figure 1 for the measurement principle. The connector specimen under test is integrated into the secondary circuit 02. The impedance-matched injection line of the primary circuit 01@ which activates the electromagnetic field@ runs parallel to the surface of the specimen under test. This test is also suitable for measuring the shielding effectiveness of a connector fitted with triaxial contacts terminated with shielded@ twisted pair cables@ as used in data bus systems. NOTE 4 This standard has been adopted by ASD-STAN (formerly known as AECMA) as EN 2591-212 .

EN 60512-23-3:2019相似标准

推荐

谁引用了EN 60512-23-3:2019 更多引用