PREN 16849-2015
沥青和沥青粘合剂 沥青乳液中水含量的测定 使用干燥天平的方法

Bitumen and bituminous binders - Determination of water content in bituminous emulsions - Method using a drying balance


 

 

非常抱歉,我们暂时无法提供预览,您可以试试: 免费下载 PREN 16849-2015 前三页,或者稍后再访问。

您也可以尝试购买此标准,
点击右侧 “购买” 按钮开始采购(由第三方提供)。

点击下载后,生成下载文件时间比较长,请耐心等待......

 

标准号
PREN 16849-2015
发布
2015年
发布单位
CEN - European Committee for Standardization
当前最新
PREN 16849-2015
 
 
适用范围
This European Standard specifies a quick method for determining@ by evaporation@ the water content of bituminous road emulsions@ with or without polymer added. For bituminous emulsions without flux oil@ bituminous emulsions containing vegetal flux oil@ and bituminous emulsions containing up to 1@5 % mass of mineral flux oil in the emulsion@ this European Standard@ according to the selected operating conditions@ is considered as an alternative method to the reference method EN 1428 [1]. Above a mineral flux oil content of 1@5 % by mass@ depending on the volatility of the flux oil: ?? the present method can be used up to a flux oil content above 1@5 % by mass if the user can prove its reliability in comparison to EN 1428. ?? the present method can only be used by correcting the result by means of a previously established correlation with the reference method EN 1428. NOTE Polymer modified emulsions can behave differently in the test than unmodified emulsions; in case of doubt@ the method is checked against EN 1428. In case of dispute@ the water content should be determined according to EN 1428. WARNING ?? The use of this European Standard can involve hazardous materials@ operations and equipment. This European Standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this European Standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For environmental reasons and to reduce emissions to air@ water and soil@ it is recommended to limit the use of products@ solvents and energy to the minimum required for a valid test result.

PREN 16849-2015相似标准


推荐

沥青乳液表征 | 道路千万条,沥青少不了

常温下,沥青是不可加工。因此,为了使沥青可加工,需采用不同工艺对其处理。最常见技术是将沥青加热到液态。另一种技术是将沥青加工成乳状液。然而,单纯将沥青混合在一起并不能形成一个稳定体系。因此,要根据具体应用需求在沥青添加一定稳定剂乳化剂。沥青乳液使用起来非常方便,同时也更容易对其储存、运输进一步加工。...

如何确定最佳油石比从而减少沥青路面病害呢?

所以,道路施工沥青混合料油石比控制好坏与否,对路面使用性能影响很大。如何确定最佳油石比?美国国家沥青技术中心(NCAT),研究出了一种既环保又经济方法测试沥青含量。NCAT管理下12个实验室轮流采用Thermo Fisher生产NCAT沥青含量测定仪仪进行现场测试,测试结果性能证明由NCAT出具报告。...

“最优道路质量”石棉沥青配比很重要哦!

我们对沥青应该不陌生,沥青主要用于涂料、塑料、橡胶等工业以及铺筑路面等。在实际应用,一般会其他材料混合从而改变沥青材料性能,比如石棉等。在道路交通方面,石棉纤维可以改善路面的使用质量。为达到最优质道路质量参数,精确控制石棉沥青配比十分重要啦。通常情况下人们通过索氏萃取方法获得实验数据,而索氏提取器使用需要大量时间,费时费力。综合以上情况,通过使用SOX500脂肪测定仪进行实验。...

稀释剂对重质油油乳液稳定性影响

摘要蒸汽辅助重力泄油技术(SAGD)是开发超稠油一项前沿技术,其机理是在注汽井中注入蒸汽,蒸汽向上超覆在地层形成蒸汽腔,蒸汽腔向上及侧面扩展,与油层原油发生热交换,加热后原油蒸汽冷凝靠重力作用泄到下面的水平生产井中产出。在这一过程中会产生复杂W/O/W乳液,为了获得无水稠油需要将乳液进行相分离。由于重质油密度与接近,经常采取稀释方法降低沥青粘度来加速相分离过程。...


PREN 16849-2015 中可能用到的仪器设备





Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号