Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 2-031: Particular requirements for hand-held probe assemblies for electrical measurement and test
ELECTRIC SHOCKS, ELECTRICAL EQUIPMENT, ELECTRICAL SAFETY, FIRE SAFETY, HANDTOOLS, LABORATORY EQUIPMENT, MARKING, MOISTURE CONTROL, PROBES, SPECIFICATIONS,THERMAL RESISTANCE
被代替标准
2004-01-01
适用范围
This National Standard of Canada is based on International Standard IEC 1010-2-031:1993. 1. Scope and Object This clause of part 1 is applicable except as follows: 1.1 Scope Replacement: This Particular Standard specifies requirements for the safety of hand-held and hand-manipulated probe assemblies designed to be used with equipment installed and used in accordance with the Rules of the Canadian Electrical Code, Part I. These requirements apply to probe assemblies of the types described below, and related accessories. These probe assemblies are for use in the interface between an electrical phenomenon and a measuring or test instrument. They may be stand-alone probe assemblies or accessories to other equipment. (a) Low-voltage and high-voltage, non-attenuating PROBE ASSEMBLIES (type A). Non-attenuating PROBE ASSEMBLIES for direct connection to voltages not exceeding 63 kV r.m.s. or d.c. They do not incorporate active components, nor are they intended to provide a voltage divider function or a signal conditioning function, but they may contain passive non-attenuating components such as fuses.
(b) High-voltage attenuating or divider PROBE ASSEMBLIES (type B). Attenuating or divider PROBE ASSEMBLIES for direct connection to voltages exceeding 1 kV r.m.s. or d.c. but not exceeding 63 kV r.m.s. or d.c. The divider function may be carried out wholly within the PROBE ASSEMBLY, or partly in the test or measuring equipment intended to be used with the PROBE ASSEMBLY.
(c) Low-voltage attenuating or divider PROBE ASSEMBLIES (type C). Attenuating, divider or other signal conditioning PROBE ASSE MBLIES for direct connection to voltages exceeding 30 V r.m.s. or 42,4 V peak or 60 V d.c., but not exceeding 1 kV r.m.s., peak or d.c. The signal conditioning function may be carried out wholly within the PROBE ASSEMBLY, or partly within the test or measuring equipment intended to be used with the PROBE ASSEMBLY.