ASTM D6117-23
塑料木材和型材机械紧固件的标准试验方法

Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes

标准号

ASTM D6117-23

发布

2023年

发布单位

美国材料与试验协会

当前最新

ASTM D6117-23

 

 

引用标准

ASTM D1761 ASTM D6111 ASTM D6341 ASTM D883 ASTM E4

适用范围

1.1 These test methods cover the evaluation of fastener use with “as manufactured” plastic lumber and shapes through the use of two different testing procedures. 1.2 The test methods appear in the following order: Sections Test Method A—Nail, Staple, or Screw Withdrawal Test 4 to 13 Test Method B—Nail, Staple, or Screw Lateral Resistance Test 14 to 22 1.3 Plastic lumber and plastic shapes are currently made predominately from recycled plastics. However, these test methods would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogeneous in the cross-section. 1.4 The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. NOTE 1—There is no known ISO equivalent to this standard. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6117-23相似标准

推荐

谁引用了ASTM D6117-23 更多引用