GSO ASTM D4294:2021
用能量色散 X 射线荧光光谱法测定石油和石油产品中硫的标准测试方法1

Standard Test Method for Sulfur in Petroleum and Petroleum Products by Energy Dispersive X-ray Fluorescence Spectrometry1


 

 

非常抱歉,我们暂时无法提供预览,您可以试试: 免费下载 GSO ASTM D4294:2021 前三页,或者稍后再访问。

您也可以尝试购买此标准,
点击右侧 “立即购买” 按钮开始采购(由第三方提供)。

 

标准号
GSO ASTM D4294:2021
发布
2021年
发布单位
GSO
当前最新
GSO ASTM D4294:2021
 
 
适用范围
1.1 This test method covers the determination of total sulfur in petroleum and petroleum products that are single-phase and either liquid at ambient conditions, liquefiable with moderate heat, or soluble in hydrocarbon solvents. These materials can include diesel fuel, jet fuel, kerosine, other distillate oil, naphtha, residual oil, lubricating base oil, hydraulic oil, crude oil, unleaded gasoline, gasoline-ethanol blends, biodiesel (see Note 2), and similar petroleum products. NOTE 1—Oxygenated fuels with ethanol or methanol contents exceeding the limits given in Table 1 can be dealt with using this test method, but the precision and bias statements do not apply (see Appendix X3). NOTE 2—For samples with high oxygen contents (>3 weight %) sample dilution as described in 1.3 or matrix matching must be performed to assure accurate results. 1.2 Interlaboratory studies on precision revealed the scope to be 17 mg ⁄ kg to 4.6 mass %. An estimate of this test method’s pooled limit of quantitation (PLOQ) is 16.0 mg ⁄ kg as calculated by the procedures in Practice D6259. However, because instrumentation covered by this test method can vary in sensitivity, the applicability of the test method at sulfur concentrations below approximately 20 mg/kg must be determined on an individual basis. An estimate of the limit of detection is three times the reproducibility standard deviation, and an estimate of the limit of quantitation2 is ten times the reproducibility standard deviation. 1.3 Samples containing more than 4.6 mass % sulfur can be diluted to bring the sulfur concentration of the diluted material within the scope of this test method. Samples that are diluted can have higher errors than indicated in Section 16 than non-diluted samples.

GSO ASTM D4294:2021相似标准


推荐

X荧光技术特点介绍

   X荧光仪是根据中华人民共和国标准GB/T17040-2008《石油产品含量测定法(能量色散X射线荧光光谱法)》规定要求设计、制造专用X荧光分析仪。    X荧光仪主要技术特点    1、采用荧光强度比率分析方法,检测品种广,带有12个标样,量程宽,分析速度快,样品耗量少。   ...

能量失散型测

.仪器采用物理分析方法检测石油石油产中含量。.适用范围:石油石油产品含量测定。.符合标准:符合GB-T 17040—2008(石油石油含量测定 能量色散x射线荧光光谱法), GB-T 17606—2009(原油含量测定 能量色散x射线荧光光潜法),SH/T 0742(汽油含量测定  能量色散x射线荧光光谱法)等标准。...

X荧光仪适合用于各类轻油、重油、原油等石油产品

石油产品该仪器完全满足如下标准: GB 11140-89 石油产品含量测定法(X射线光谱法)1990-04-01 GB/T 17040-1997石油产品含量测定法(能量色散X射线荧光光谱法)1998-04-01 SH/T 0742-2004 汽油含量测定法(能量色散X射线荧光光谱法) 2004-04-30 D4294-023 ASTM 石油产品含量测定标准(EDXRF)(美国国家标准)...

使用XRF光谱仪对原油进行元素分析

如今,许多炼油厂实验室石化测试实验室中都可以见到X-Supreme8000LAB-X5000台式分析仪身影,其可以帮助您符合以下要求:ASTMD4294:能量色散X射线荧光光谱法测定石油石油产品标准测试方法ISO8754:石油产品 - 含量测定 - 能量扩散式X射线荧光测定法IP336:石油产品 - 含量测定 - 能量扩散式X射线荧光测定法EPA9075:X射线荧光测定法测定新旧石油产品总氯测试方法...





Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号