BS 7859-1996
天燃气.热值、密度、相对密度和由化合物推导的沃泊指数的计算

Natural gas - Calculation of calorific values, density, relative density and Wobbe index from composition

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 BS 7859-1996 前三页，或者稍后再访问。

如果您需要购买此标准的全文，请联系： 。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 BS 7859-1996 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

BS 7859-1996

发布日期

1996年03月15日

实施日期

1996年03月15日

废止日期

无

中国标准分类号

E24

国际标准分类号

75.060

发布单位

GB-BSI

代替标准

BS EN ISO 6976-2005

适用范围

This International Standard specifies methods for the calculation of the superior calorific value, inferior calorific value, density, relative density and Wobbe index of dry natural gases, natural gas substitutes and other combustible gaseous fuels, when the compo-sition of the gas by mole fraction is known. The methods provide a means of calculating the proper-ties of the gas mixture at commonly used metric ref-erence conditions. The methods of calculation require values for various physical properties of the pure components; these values are provided in tables and their sources are identified. Methods are given for estimating the precision of calculated properties. The methods of calculation of the values of properties on either a molar or mass basis are applicable to any dry natural gas, natural gas substitute or other combustible fuel which is normally gaseous. For the calculation of the values of properties on a volumetric basis, the methods are restricted to gases consisting preponderantly of methane (not less than 0,5 mole fraction). Examples of calculations are given in annex D for the recommended methods of calculation. NOTES 1 The symbols used in this International Standard, to-gether with their meanings, are given in annex A. 2 The qualifiers "higher", "upper", "total" and "gross" are, for the purposes of this International Standard, syn-onymous with "superior"; likewise, "lower" and "net" are synonymous with "inferior". The term "heating value" is synonymous with "calorific value"; "specific gravity" is synonymous with "relative density"; "Wobbe number" is synonymous with "Wobbe index"; "compressibility factor" is synonymous with "compression factor". 3 If the composition of the gas is known by volume frac-tions these must be converted to mole fractions (see annex C). Note, however, that the derived mole fractions will have uncertainties greater than those of the original volume fractions. 4 For the purposes of this International Standard, the sum of the mole fractions used must be unity to the nearest 0,000 1, and all components with mole fractions greater than 0,000 05 must be accounted for. 5 For the calorific value calculated on a volumetric basis, there are limitations on the amounts of components other than methane which may be present. It is impossible to be definitive on this matter, but the following guidelines may be useful: N2 should not be present in amounts exceeding 0,3 mole fraction; CO2 and C2H6 should each not exceed 0,15 mole frac-tion; no other component should exceed 0,05 mole fraction. Given these limits, the expected trueness of the calculation is within 0,1 %. 6 The effects of water vapour on the calorific value, either directly measured or calculated, are discussed in annex F. 7 For the methods of calculation described to be valid, the gas must be above its hydrocarbon dew-point at the pre-scribed reference conditions. 8 The values of basic physical property data are subject to revision as more accurate values become available from authoritative sources.