IEC 61037-1998
电量测量 电费和负荷控制 电子式纹波控制接收机的特殊要求
Electricity metering - Tariff and load control - Particular requirements for electronic ripple control receivers
IEC 61037-1998 发布历史
This International Standard specifies requirements for the type test of indoor electronic ripple control receivers for the reception and interpretation of pulses of a single audio frequency superimposed on the voltage of the electricity distrivution network and for the execution of the corresponding switching operations. In this system the mains frequency is generally used to synchronize the transmitter and receivers. Neither the control frequency,nor the encoding are standardized in this standard. This standard gives no requirements for constructional details internal to the receiver.This standard does not cover the acceptance tests and the conformity tests.(Nevertheless, an example of what could be an acceptance test is given in annex G(informative).) The reliability aspect also is not covered in this standard as there are no short term procedures available which would fit into type test documents to satisfactorily check this requirement.
IEC 61037-1998由国际电工委员会 IX-IEC 发布于 1998-08。
IEC 61037-1998 在中国标准分类中归属于: N22 电能测量和负荷控制系统。
IEC 61037-1998的历代版本如下：
- 1990年10月 IEC 61037-1990 计费和负载控制用电子脉动控制接收装置
- 1998年08月01日 IEC 61037-1998 Comptage De L'Electricite - Tarification Et Controle De Charge - Prescriptions Particulieres Pour Recepteurs Electroniques De Telecommande Centralisee (Edition 1.2: Edition 1: 1990 Consolidated with Amendments 1: 1996 and 2: 1998)
- 适用范围
- This International Standard specifies requirements for the type test of indoor electronic ripple control receivers for the reception and interpretation of pulses of a single audio frequency superimposed on the voltage of the electricity distrivution network and for the execution of the corresponding switching operations. In this system the mains frequency is generally used to synchronize the transmitter and receivers. Neither the control frequency,nor the encoding are standardized in this standard. This standard gives no requirements for constructional details internal to the receiver.This standard does not cover the acceptance tests and the conformity tests.(Nevertheless, an example of what could be an acceptance test is given in annex G(informative).) The reliability aspect also is not covered in this standard as there are no short term procedures available which would fit into type test documents to satisfactorily check this requirement.