BS ISO 15561-1998
重铬酸盐剂量测定系统的使用规程

Practice for use of a dichromate dosimetry system


 

 

非常抱歉,我们暂时无法提供预览,您可以试试: 免费下载 BS ISO 15561-1998 前三页,或者稍后再访问。

如果您需要购买此标准的全文,请联系:

点击下载后,生成下载文件时间比较长,请耐心等待......

 

标准号
BS ISO 15561-1998
发布日期
1999年09月15日
实施日期
1999年09月15日
废止日期
中国标准分类号
F81
国际标准分类号
17.240
发布单位
GB-BSI
被代替标准
97/703079 DC-1997
适用范围
1 This practice covers the preparation, testing, and procedure for using the acidic aqueous silver dichromate dosimetry system to measure absorbed dose in water when exposed to ionizing radiation. The system consists of a dosimeter and appropriate analytical instrumentation. For simplicity, the system will be referred to as the dichromate system. It is classified as a reference standard dosimetry system (see Guide E 1261). 2 This practice describes the spectrophotometric anal-ysis procedures for the dichromate system. 3 This practice applies only to γ-rays, x-rays, and high energy electrons. 4 This practice applies provided the following condi-tions are satisfied: 4.1 The absorbed dose range is from 2 × 10 to 5 × 10 Gy. 4.2 The absorbed dose rate does not exceed 600 Gy/ pulse with a pulse repetition rate not to exceed 12.5 Hz, or does not exceed an equivalent dose rate of 7.5 kGy/s from continuous sources (1). 4.3 For radionuclide gamma-ray sources, the initial photon energy shall be greater than 0.6 MeV. For bremsstrahlung photons, the initial energy of the electrons used to produce the bremsstrahlung photons shall be equal to or greater than 2 MeV. For electron beams, the initial electron energy shall be greater than 8 MeV. Note 1—The lower energy limits given are appropriate for a cylindrical dosimeter ampoule of 12 mm diameter. Corrections for displacement effects and dose gradient across the ampoule may be required for electron beams (2). The dichromate system may be used at lower energies by employing thinner (in the beam direction) dosimeter containers (see ICRU Report 35). 4.4 The irradiation temperature of the dosimeter shall be above 0℃ and should be below 80℃. Note 2—The temperature coefficient of dosimeter response is known only in the range of 5℃ to 50℃ (see 10.1.8). Use outside this range is not recommended. 5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use. Specific precau-tionary statements are given in Note 6.




Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号