FITTING END, BOLT CLUSTER FITTING, DOUBLE PORT, THROUGH, FLARELESS FSC 4730; Should Be Used Instead of MS21935C, Which Was Cancelled on 07 September 1999
FITTING END, BOLT CLUSTER FITTING, DOUBLE PORT, THROUGH, FLARELESS FSC 4730; Should Be Used Instead of MS21935C, Which Was Cancelled on 07 September 1999ALL OUTSIDE MACHINED SURFACES FINISHED TO 125 RHR MAX, EXCEPT AS NOTED.ALL INSIDE MACHINED SURFACES FINISHED TO 250 RHR MAX, EXCEPT AS NOTED.M MACHINED SURFACES FINISHED TO 16 RHR MAX AND CONCENTRIC TO EACH OTHER WITHIN .0005 TIR.SURFACE FINISH IN ACCORDANCE WITH ANSI B46.1.L AND M DIA AND THREAD T MUST BE CONCENTRIC WITHIN .005 TIR.FITTINGS SHALL BE FREE FROM ALL HANGING BURRS AND SLIVERS.DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TOLERANCES: DECIMALS –.010, ANGLES –1/2°.CERTAIN PROVISIONS (SCREW THREADS) OF THIS STANDARD ARE THE SUBJECT OF INTERNATIONALSTANDARDIZATION AGREEMENT ASCC AIR STD 17/15. WHEN REVISION OR CANCELLATION OF THISSTANDARD IS PROPOSED WHICH WILL AFFECT OR VIOLATE THE INTERNATIONAL AGREEMENTCONCERNED, THE PREPARING ACTIVITY WILL TAKE APPROPRIATE RECONCILIATION ACTION THROUGHINTERNATIONAL STANDARDIZATION CHANNELS, INCLUDING DEPARTMENTAL STANDARDIZATION OFFICES,IF REQUIRED.IN THE EVENT OF A CONFLICT BETWEEN THE TEXT OF THIS STANDARD AND THE REFERENCES CITEDHEREIN, THE TEXT OF THIS STANDARD SHALL TAKE PRECEDENCE.REFERENCED GOVERNMENT (OR NON-GOVERNMENT) DOCUMENTS OF THE ISSUE LISTED IN THAT ISSUEOF THE DEPARTMENT OF DEFENSE INDEX OF SPECIFICATIONS AND STANDARDS (DoDISS) SPECIFIED INTHE SOLICITATION FORM A PART OF THIS STANDARD TO THE EXTENT SPECIFIED HEREIN.THIS IS A DESIGN STANDARD. NOT TO BE USED AS A PART NUMBER.