IEC 60947-3 Edition 2.1:2001
低压开关设备和控制设备.第3部分:开关、隔离开关、开关-隔离开关和保险丝组合部件已作废

Low-voltage switchgear and controlgear - Part 3: Switches, disconnectors, switch-disconnectors and fuse-combination units

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 IEC 60947-3 Edition 2.1:2001 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

IEC 60947-3 Edition 2.1:2001

发布日期

2001年05月

实施日期

废止日期

2008-08

中国标准分类号

K31

国际标准分类号

29.130.20

发布单位

国际电工委员会

代替标准

IEC 60947-3:2008

适用范围

This standard applies to switches, disconnectors, switch-disconnectors and fuse-combination units to be used in distribution circuits and motor circuits of which the rated voltage does not exceed 1 000 V a.c. or 1 500 V d.c. The manufacturer shall specify the type, ratings and characteristics according to the relevant standard of any incorporated fuses. This standard does not apply to equipment coming within the scope of IEC 60947-2, IEC 60947-4-1 and IEC 60947-5-1; however, when switches and fuse-combination units coming into the scope of this standard are normally used to start, accelerate and/or stop an individual motor they shall also comply with the additional requirements given in annex A. The requirements for single pole operated three pole switches are included in Annex C. Auxiliary switches fitted to equipment within the scope of this standard shall comply with the requirements of IEC 60947-5-1. This standard does not include the additional requirements necessary for electrical apparatus for explosive gas atmospheres. NOTE 1 Depending on its design, a switch (or disconnector) can be referred to as "a rotary switch (disconnector)", "cam-operated switch (disconnector)", "knife-switch (disconnector)", etc. NOTE 2 In this standard, the word "switch" also applies to the apparatus referred to in French as "commutateurs", intended to modify the connections between several circuits and inter alia to substitute a part of a circuit for another. NOTE 3 In general, throughout this standard switches, disconnectors, switch-disconnectors and fuse-combination units will be referred to as "equipment". The object of this standard is to state a) the characteristics of the equipment; b) the conditions with which the equipment shall comply with reference to 1) operation and behaviour in normal service; 2) operation and behaviour in case of specified abnormal conditions, e.g. short circuit; 3) dielectric properties; c) the tests for confirming that these conditions have been met and the methods to be adopted for these tests; d) the information to be marked on the equipment or made available by the manufacturer, e.g. in the catalogue.

IEC 60947-3 Edition 2.1:2001相似标准

推荐