ANSI/ASTM B574-1999
低碳镍钼铬,低碳镍铬钼和低碳镍铬钼钨合金棒规范

Specification for Low-Carbon Nickel-Molybdenum-Chromium, Low-Carbon Nickel-Chromium-Molybdenum and Low-Carbon Nickel-Chromium-Molybdenum-Tungsten Alloy Rod

ANSI/ASTM B574-1999 发布历史

This specification covers rod of low-carbon nickel-molybdenum-chromium alloys (UNS N10276, N06022, and N06455) , low-carbon nickel-chromium-molybdenum alloy (UNS N06059), and low-carbon nickel-chromium-molybdenum-tungsten (UNS N06686) as shown in Table 1, for use in general corrosive service. The following products are covered under this specification:Rods 5/16 to 3/4 in. (7.94 to 19.05 mm), exclusive, in diameter, hot or cold finished, solution annealed and pickled, or mechanically descaled. Rods 3/4 to 3 1/2 in. (19.05 to 88.9 mm), inclusive, in diameter, hot or cold finished, solution annealed, ground or turned.The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

ANSI/ASTM B574-1999由美国国家标准学会 US-ANSI 发布于 1999。

ANSI/ASTM B574-1999 在中国标准分类中归属于: H44 型钢、异型钢，在国际标准分类中归属于: 77.150.40 镍和铬产品。

ANSI/ASTM B574-1999的历代版本如下：

• 1999年 ANSI/ASTM B574-1999 低碳镍钼铬,低碳镍铬钼和低碳镍铬钼钨合金棒规范

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ANSI/ASTM B574-1999 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ANSI/ASTM B574-1999

发布日期

1999年

实施日期

废止日期

无

中国标准分类号

H44

国际标准分类号

77.150.40

发布单位

US-ANSI

适用范围

This specification covers rod of low-carbon nickel-molybdenum-chromium alloys (UNS N10276, N06022, and N06455) , low-carbon nickel-chromium-molybdenum alloy (UNS N06059), and low-carbon nickel-chromium-molybdenum-tungsten (UNS N06686) as shown in Table 1, for use in general corrosive service. The following products are covered under this specification:Rods 5/16 to 3/4 in. (7.94 to 19.05 mm), exclusive, in diameter, hot or cold finished, solution annealed and pickled, or mechanically descaled. Rods 3/4 to 3 1/2 in. (19.05 to 88.9 mm), inclusive, in diameter, hot or cold finished, solution annealed, ground or turned.The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.