ANSI/ASTM D705-1999
脲甲醛模制化合物规范(08.01)

Specification for Urea-Formaldehyde Molding Compounds (08.01)

ANSI/ASTM D705-1999 发布历史

This specification covers compression molding thermosetting, urea-formaldehyde molding compounds as further defined in . The values stated in SI units are to be regarded as the standard. Note 1The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding. The following safety hazards caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 2ISO 2112-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not the same.

ANSI/ASTM D705-1999由美国国家标准学会 US-ANSI 发布于 1999，并于 2004 实施。

ANSI/ASTM D705-1999 在中国标准分类中归属于: G31 合成树脂、塑料基础标准与通用方法，在国际标准分类中归属于: 83.140.99 其他橡胶和塑料制品。

ANSI/ASTM D705-1999的历代版本如下：

• 1999年 ANSI/ASTM D705-1999 脲甲醛模制化合物规范(08.01)

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ANSI/ASTM D705-1999 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ANSI/ASTM D705-1999

发布日期

1999年

实施日期

2004年

废止日期

无

中国标准分类号

G31

国际标准分类号

83.140.99

发布单位

US-ANSI

适用范围

This specification covers compression molding thermosetting, urea-formaldehyde molding compounds as further defined in . The values stated in SI units are to be regarded as the standard. Note 1The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding. The following safety hazards caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 2ISO 2112-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not the same.