ANSI/ASTM D5934:1997
用三点弯曲法测定在装载控制速度下刚性和半刚性塑料样品弹性模量的方法

Test Method for Determination of the Modulus of Elasticity for Rigid and Semi-Rigid Plastic Specimens by Controlled Rate of Loading Using Three Point Bending

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ANSI/ASTM D5934:1997 前三页，或者稍后再访问。

如果您需要购买此标准的全文，请联系： 。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ANSI/ASTM D5934:1997 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ANSI/ASTM D5934:1997

发布

1997年

发布单位

美国国家标准学会

 

 

适用范围

This test method covers the use of controlled rate of loading mechanical instrumentation for gathering and reporting the modulus of elasticity of thermoplastic and thermosetting resins and composite systems in the form of rectangular bars molded directly or cut from sheets, plates, or molded shapes. The data generated, using three-point bending techniques, may be used to identify the thermomechanical properties of a plastics material or composition using a controlled rate of loading mechanical instrument. Results obtained from this test method may or may not be comparable to results obtained using D 790. This test method is intended to provide a means for determining the modulus of elasticity within the linear region of the stress-strain curve (see Fig 1). This test is conducted at standard temperature and pressure. Apparent discrepancies may arise in results obtained under differing experimental conditions. These apparent differences from results observed in another study can usually be reconciled, without changing the observed data, by reporting in full (as described in this test method) the conditions under which the data were obtained. The values stated in SI units are to be regarded as the standard. The values stated in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1 -There is no similar or equivalent ISO standard.

ANSI/ASTM D5934:1997相似标准

推荐