ASME PTC 29-2005
液压汽轮发电机组的速度调节系统

Speed-Governing Systems for Hydraulic Turbine-Generator Units

ASME PTC 29-2005 发布历史

This Code applies to speed governors used on conventional, constant-speed hydraulic turbines. This Code is applicable to electronic-hydraulic and mechanical-hydraulic speed governors. These governors are commonly used to control reaction and impulse-type-hydraulic turbines (fixed or variable geometry) and pump turbines operating in generation mode. This Code specifies procedures for conducting tests to determine the following performance characteristics of hydraulic turbine speed governors: (a) droop: (1) permanent, (2) temporary; (b) deadband and deadtime: (1) speed, (2) position, (3) power; (c) stability index: (1) governing speedband, (2) governing powerband; (d) step response; (e) gain: (1) proportional gain, (2) integral gain, (3) derivative gain; (f) setpoint adjustment: (1) range of adjustment, (2) ramp rate. This Code also establishes the rules and procedures for the conduct of tests to determine the following operational characteristics of hydraulic turbine speed governors: (a) gate/blade relationship (dual regulated reaction turbines), (b) needle/deflector relationship (impulse turbines), (c) full-rate servomotor timing and cushion time.

ASME PTC 29-2005由美国机械工程师协会 US-ASME 发布于 2005。

ASME PTC 29-2005 在中国标准分类中归属于: K55 水轮机及其辅助设备，在国际标准分类中归属于: 27.140 水力工程。

ASME PTC 29-2005的历代版本如下：

• 1965年 ASME PTC 29-1965 液压汽轮发电机组的速度调节系统
• 2005年 ASME PTC 29-2005 液压汽轮发电机组的速度调节系统

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ASME PTC 29-2005 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ASME PTC 29-2005

发布日期

2005年

实施日期

废止日期

无

中国标准分类号

K55

国际标准分类号

27.140

发布单位

US-ASME

被代替标准

ASME PTC 29-1965

适用范围

This Code applies to speed governors used on conventional, constant-speed hydraulic turbines. This Code is applicable to electronic-hydraulic and mechanical-hydraulic speed governors. These governors are commonly used to control reaction and impulse-type-hydraulic turbines (fixed or variable geometry) and pump turbines operating in generation mode. This Code specifies procedures for conducting tests to determine the following performance characteristics of hydraulic turbine speed governors: (a) droop: (1) permanent, (2) temporary; (b) deadband and deadtime: (1) speed, (2) position, (3) power; (c) stability index: (1) governing speedband, (2) governing powerband; (d) step response; (e) gain: (1) proportional gain, (2) integral gain, (3) derivative gain; (f) setpoint adjustment: (1) range of adjustment, (2) ramp rate. This Code also establishes the rules and procedures for the conduct of tests to determine the following operational characteristics of hydraulic turbine speed governors: (a) gate/blade relationship (dual regulated reaction turbines), (b) needle/deflector relationship (impulse turbines), (c) full-rate servomotor timing and cushion time.