SAE J 1304-2006
带螺栓孔的切割边交叉直装货设备

Cutting Edge Cross Sections Loader Straight with Bolt Holes

SAE J 1304-2006 发布历史

For cutting edges used on buckets for loaders defined in SAE J1057a. The dimensions are applicable to rolled and machined sections only. Cutting edge cross section thickness is limited to a maximum of 35 mm. Bolt-on tooth adapters are rarely used on loader buckets with cutting edge thicknesses in excess of 35 mm. This recommended practice applies only to straight cutting edges defined as those whose leading edge and rear edge are parallel and thus are of constant cross section. Overall cross sections to which bolt holes were added as indicated by this recommended practice were selected from those indicated per "Cutting Edge-Cross Sections Loader Straight, " SAE J1303 FEB85. Selection was based on minimum section width requirements to accommodate bolt-on tooth adapters. To specify dimensions for straight cutting edge cross sections with bolt holes for mounting bolt-on tooth adapters on loader buckets described by SAE J731d. It is the intent of this recommended practice to describe the cross sections viable for bolt-on tooth mounting and identify the bolt hole size and location relative to the cutting edge cross section. Thus, a foundation for future standardization of bolt-on tooth adapters is established by the recommended practice.

SAE J 1304-2006由美国机动车工程师协会 US-SAE 发布于 2006-02-01。

SAE J 1304-2006 在中国标准分类中归属于: J62 锻压机械，在国际标准分类中归属于: 53.100 土方机械。

SAE J 1304-2006的历代版本如下：

• 2006年02月01日 SAE J 1304-2006 带螺栓孔的切割边交叉直装货设备
• 2011年10月25日 SAE J 1304-2011 带有螺栓孔的切边横截面装载机

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 SAE J 1304-2006 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

SAE J 1304-2006

发布日期

2006年02月01日

实施日期

废止日期

无

中国标准分类号

J62

国际标准分类号

53.100

发布单位

US-SAE

代替标准

SAE J 1304-2011

适用范围

For cutting edges used on buckets for loaders defined in SAE J1057a. The dimensions are applicable to rolled and machined sections only. Cutting edge cross section thickness is limited to a maximum of 35 mm. Bolt-on tooth adapters are rarely used on loader buckets with cutting edge thicknesses in excess of 35 mm. This recommended practice applies only to straight cutting edges defined as those whose leading edge and rear edge are parallel and thus are of constant cross section. Overall cross sections to which bolt holes were added as indicated by this recommended practice were selected from those indicated per "Cutting Edge-Cross Sections Loader Straight, " SAE J1303 FEB85. Selection was based on minimum section width requirements to accommodate bolt-on tooth adapters. To specify dimensions for straight cutting edge cross sections with bolt holes for mounting bolt-on tooth adapters on loader buckets described by SAE J731d. It is the intent of this recommended practice to describe the cross sections viable for bolt-on tooth mounting and identify the bolt hole size and location relative to the cutting edge cross section. Thus, a foundation for future standardization of bolt-on tooth adapters is established by the recommended practice.

SAE J 1304-2006 中可能用到的仪器设备

谁引用了SAE J 1304-2006 更多引用