SAE J 2271-1996
针对双头螺栓的船舶系统和设备部分标准,连续和双端(英制系列)

Ship Systems and Equiment Part Standard for Studs Continous and Double End (Inch Series)

SAE J 2271-1996 发布历史

This SAE Parts Standard provides dimensional and quality assurance requirements for 1/4 through 2 in sizes of studs in the following configurations in standard materials used for ship system applications: a. continuous thread studs in UNRC and 8UNF series; b. double end studs (clamping type) where both ends are of the same thread series (UNRC or 8UN). Also called bolt-studs. (These are suitable for mating with nuts or the set end may be installed with anaerobic thread locking compound.); and c. double end studs (interference thread type) with the nut end having UNRC or 8UNR series thread and where the tap end has NC 5 HFS interference fit thread forms. Also called a tape end stud. A complete metric companion to this document is provided in sAE J2271M, therefore no metric equivalents are presented.

SAE J 2271-1996由美国机动车工程师协会 US-SAE 发布于 1996-06-01。

SAE J 2271-1996 在中国标准分类中归属于: J13 紧固件，在国际标准分类中归属于: 21.060.01 紧固件综合。

SAE J 2271-1996的历代版本如下：

• 1996年06月01日 SAE J 2271-1996 针对双头螺栓的船舶系统和设备部分标准,连续和双端(英制系列)
• 2009年05月05日 SAE J 2271-2009 船舶系统和设备.柱头螺栓用部分标准.连续作用和双端引线(米制系列)

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 SAE J 2271-1996 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

SAE J 2271-1996

发布日期

1996年06月01日

实施日期

废止日期

无

中国标准分类号

J13

国际标准分类号

21.060.01

发布单位

US-SAE

代替标准

SAE J 2271-2004

适用范围

This SAE Parts Standard provides dimensional and quality assurance requirements for 1/4 through 2 in sizes of studs in the following configurations in standard materials used for ship system applications: a. continuous thread studs in UNRC and 8UNF series; b. double end studs (clamping type) where both ends are of the same thread series (UNRC or 8UN). Also called bolt-studs. (These are suitable for mating with nuts or the set end may be installed with anaerobic thread locking compound.); and c. double end studs (interference thread type) with the nut end having UNRC or 8UNR series thread and where the tap end has NC 5 HFS interference fit thread forms. Also called a tape end stud. A complete metric companion to this document is provided in sAE J2271M, therefore no metric equivalents are presented.

SAE J 2271-1996 中可能用到的仪器设备