IEC 60947-4-3:2007
低压开关设备和控制设备.第4-3部分:电流接触器和电动机起动器 非电动机负载用交流半导体控制器和电流接触器

Low-voltage switchgear and controlgear - Part 4-3: Contactors and motor-starters - AC semiconductor controllers and contactors for non-motor loads

被代替

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 IEC 60947-4-3:2007 前三页，或者稍后再访问。

您也可以尝试购买此标准，
点击右侧 “购买” 按钮开始采购（由第三方提供）。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

IEC 60947-4-3:2007

发布

2007年

发布单位

国际电工委员会

替代标准

IEC 60947-4-3:2011

当前最新

IEC 60947-4-3:2020

 

 

适用范围

This part of IEC 60947 applies to a.c. semiconductor non-motor load controllers and contactors intended for performing electrical operations by changing the state of a.c. electric circuits between the ON-state and the OFF-state. Typical applications are given in table 2. As controllers, they may be used to reduce the amplitude of the r.m.s. a.c. voltage on the load terminals from that of the applied voltage – either continuously or for a specified period of time. The half-wave period of the a.c. wave form remains unchanged from that of the applied voltage. They may include a series mechanical switching device and are intended to be connected to circuits, the rated voltage of which does not exceed 1 000 V a.c. This standard characterizes controllers and contactors for use with or without bypass switching devices. The semiconductor controllers and contactors dealt with in this standard are not normally intended to interrupt short-circuit currents. Therefore, suitable short-circuit protection (see 8.2.5) should form part of the installation but not necessarily of the controller itself. In this context, this standard gives requirements for semiconductor controllers and contactors associated with separate short-circuit protective devices. This standard does not apply to ? operation of a.c. and d.c. motors; ? low-voltage a.c. semiconductor motor controllers and starters covered by IEC 60947-4-2; ? electronic a.c. power controllers covered by IEC 60146; ? all-or-nothing solid-state relays. Contactors and control-circuit devices used in semiconductor controllers and contactors should comply with the requirements of their relevant product standard. Where mechanical switching devices are used, they should meet the requirements of their own IEC product standard and the additional requirements of this standard.

IEC 60947-4-3:2007相似标准

推荐

谁引用了IEC 60947-4-3:2007 更多引用