1/ Dimensions are in inches.
2/ Metric equivalents are given for general information only.
3/ Unless otherwise specified, tolerance is ±.010 (0.25 mm).
4/ Terminal numbers need not appear on relay header provided there is affixed to the relay a suitable legible circuit
diagram that permanently and positively identifies each terminal location specified herein.
5/ In the event of conflict between the text of this specification and the references cited herein, the text of this
specification shall take precedence.
6/ Referenced Government documents of the issue listed in that issue of the Department of Defense Index of
Specifications and Standards (DoDISS) specified in the solicitation forms a part of this specification to the extent specified herein.