ASTM E2092-2003
热机分析三点弯曲处变形温度的标准试验方法

Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ASTM E2092-2003 前三页，或者稍后再访问。

如果您需要购买此标准的全文，请联系： 。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ASTM E2092-2003

发布日期

2003年

实施日期

废止日期

无

中国标准分类号

A42

发布单位

US-ASTM

适用范围

1.1 This test method describes the determination of the temperature at which the specific modulus of a test specimen is realized by deflection in three-point bending. This temperature is identified as the distortion temperature measured. The distortion temperature is that temperature at which a test specimen of defined geometry deforms to a level of strain under applied stress of 0.455 and 1.82 MPa (66 and 264 psi) equivalent to those used in Test Method D 648. The test may be performed over the range of temperature from ambient to 300C.

Note 1

Results may or may not agree with those obtained by Test Method D 648.

1.2 Electronic instrumentation or automated data analysis and reduction systems or treatments equivalent to this test method may be used.

Note 2

Since all electronic data treatments are not equivalent, the user shall verify equivalency to this test method.

1.3 SI values are to be regarded as the standard. Inch-pound units in parentheses are for information only.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

1.5 There is no ISO standard equivalent to this test method.

谁引用了ASTM E2092-2003 更多引用