ASTM E2008-1999
用热解重量分析法测定散热率的标准试验方法

Standard Test Method for Volatility Rate by Thermogravimetry

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ASTM E2008-1999 前三页，或者稍后再访问。

如果您需要购买此标准的全文，请联系： 。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ASTM E2008-1999

发布日期

1999年

实施日期

废止日期

无

中国标准分类号

A42

国际标准分类号

71.040.50 (Physicochemical methods of analysis)

发布单位

US-ASTM

适用范围

1.1 This test method covers procedures for assessing the volatility of solids and liquids at given temperatures using thermogravimetry under prescribed experimental conditions. Results of this test method are obtained as volatility rates expressed as mass per unit time. Rates 062 or 061 to 5 181g/min are achievable with this test method.

1.2 Temperatures typical for this test method are within the range from 25 176C to 500176C. This temperature range may differ depending upon the instrumentation used.

1.3 This test method is intended to provide a value for the volatility rate of a sample using a thermogravimetric analysis measurement on a single representative specimen. It is the responsibility of the user of this test method to determine the need for and the number of repetitive measurements on fresh specimens necessary to satisfy end use requirements.

1.4 Computer- or electronic-based instruments, techniques, or data treatment equivalent to this test method may also be used.

Note 1-Users of this test method are expressly advised that all such instruments or techniques may not be equivalent. It is the responsibility of the user of this test method to determine the necessary equivalency prior to use.

1.5 The values stated in SI units are to be regarded as the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.