ASTM E289-1999
用干涉测量测试刚性固体的线性热膨胀的试验方法

Standard Test Method for Linear Thermal Expansion of Rigid Solids with Interferometry

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ASTM E289-1999 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ASTM E289-1999

发布日期

1999年

实施日期

废止日期

无

中国标准分类号

A52

国际标准分类号

19.060 (Mechanical testing)

发布单位

US-ASTM

适用范围

1.1 This test method covers the determination of linear thermal expansion of rigid solids using either a Michelson or Fizeau interferometer.

1.2 For this purpose, a rigid solid is defined as a material which, at test temperature and under the stresses imposed by instrumentation, has a negligible creep or elastic strain rate, or both, insofar as significantly affecting the precision of thermal length change measurements. This includes metals, ceramics, refractories, glasses, rocks and minerals, graphites and fiber, and other reinforced matrix composites.

1.3 It is recognized that many rigid solids require detailed preconditioning and specific thermal test schedules for correct evaluation of linear thermal expansion behavior for certain material applications. Since a general method of test cannot cover all specific requirements, details of this nature should be discussed in the particular material specifications.

1.4 This test method is applicable to the approximate temperature range -150 to 700176C. The temperature range may be extended depending on the instrumentation and calibration materials used.

1.5 The precision of measurement of this absolute method (better than +40 nm/m[dot]K) is significantly higher than that of comparative methods such as push rod dilatometry (for example, Test Methods D696 and E228) and thermomechanical analysis (for example, Test Method E831) techniques. It is more applicable to materials having low and, or negative coefficients, or both, of expansion (below 5 [mu]m/m[dot]K) and where only very limited lengths or thickness of other higher expansion coefficient materials are available.

1.6 Computer of electronic based instrumentation, techniques and data analysis systems equivalent to this test method can be used. Users of the test method are expressly advised that all such instruments or techniques may not be equivalent. It is the responsibility of the user to determine the necessary equivalency prior to use.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM E289-1999 中可能用到的仪器设备