非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ASTM D1921-2006 前三页，或者稍后再访问。
如果您需要购买此标准的全文，请联系： 。
点击下载后，生成下载文件时间比较长，请耐心等待......
These test methods can be used to determine particle size distribution and therefore are useful for determining lot-to-lot uniformity.
The particle sizes of plastic materials affect the handling characteristics and sometimes will affect the processing characteristics of some polymers.
1.1 These test methods cover the measurement of the particle size of plastic materials in the powdered, granular, or pelleted forms in which they are commonly supplied. As these test methods utilize dry sieving, the lower limit of measurement is considered to be about 38 m (No. 400 sieve). For smaller particle sizes, sedimentation test methods are recommended.
1.2 Two test methods are described:
1.2.1 Test Method AThis test method uses multiple sieves selected to span the particle size of the material. This method is used to determine the mean particle diameter and particle size distribution.
1.2.2 Test Method BThis test method is an abbreviated version of Test Method A conducted with a few specific sieves. This test method determines "percent passing" or "percent retained" on a given sieve. Test Method B is applicable to materials which do not have a normal particle size distribution such as pellets and cubes.
1.3 The values stated in SI units shall be considered standard for dimensions of the wire cloth openings and the diameter of the wires used in the wire cloth. The values stated in inch-pound units shall be considered standard with regard to the sieve frames.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
There is no technically equivalent ISO standard.
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证：京ICP证110310号