找不到引用ASTM D6035-2008 使用一柔壁渗透计对压实的或原状土壤样品液体导电性冻融效果测定的标准试验方法 的标准
This test method identifies the changes in hydraulic conductivity as a result of freeze-thaw on natural soils only.
It is the user''s responsibility when using this test method to determine the appropriate moisture content of the laboratory-compacted specimens (that is, dry, wet, or at optimum moisture content) (Note 2).
Note 28212;It is common practice to construct clay liners and covers at optimum or greater than optimum moisture content. Specimens compacted dry of optimum moisture content typically do not contain larger pore sizes as a result of freeze-thaw because the effects of freeze-thaw are minimized by the lack of water in the sample. Therefore, the effect of freeze-thaw on the hydraulic conductivity is minimal, or the hydraulic conductivity may increase slightly. ,
The requestor must provide information regarding the effective stresses to be applied during testing, especially for determining the final hydraulic conductivity. Using high effective stresses (that is, 35 kPa (5 psi) as allowed by Test Method D 5084
The specimen shall be frozen to x2212;15x00B0;C unless the requestor specifically dictates otherwise. It has been documented in the literature that the initial (that is, 0 to x2212;15x00B0;C) freezing condition causes the most significant effects in hydraulic conductivity. Freezing rate and ultimate temperature should mimic the field conditions. It has been shown that superfreezing (that is, freezing the specimen at very cold temperatures and very short time periods) produces erroneous results.
The thawed specimen temperature and thaw rate shall mimic field conditions. Thawing specimens in an oven (that is, overheating) will produce erroneous results.
Literature relating to this subject indicates that the effects of freeze-thaw usually occur by Cycle 10, thus it is recommended that at least 10 freeze-thaw cycles shall be performed to ensure that the full effects of freeze-thaw are measured. If the hydraulic conductivity values are still increasing after 10 freeze-thaw cycles, the test method shall be continued (that is, more freeze-thaw cycles shall be performed).
Note 38212;The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. Agencies that meet the criteria of Practice D 3740
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号