ASTM D6175-2003(2008)
挤压催化剂和催化剂载体颗粒辐射抗压强度的标准试验方法

Standard Test Method for Radial Crush Strength of Extruded Catalyst and Catalyst Carrier Particles

标准号

ASTM D6175-2003(2008)

发布日期

2003年

实施日期

废止日期

无

中国标准分类号

G74

国际标准分类号

19.060 (Mechanical testing)

发布单位

US-ASTM

适用范围

This test method is intended to provide information on the ability of an extruded catalyst to retain physical integrity during use.

1.1 This test method covers and is suitable for determining the resistance of extruded catalysts and catalyst carriers to compressive force from the side.

1.2 This test method was developed using extruded catalyst and catalyst carriers from ¹/₁₆to ¹/₈ in. in diameter (0.159 to 0.318 cm) and limited to pieces with a length to diameter ratio greater than or equal to 1:1. This test method may be applicable to other diameters.

1.3 This test method is suitable for the determination of mean crush strength per millimetre in the range of 0 to 15 lbf/mm (0 to 65 N/mm).

1.4 The values stated in pounds lbf/mm units are to be regarded as the standard. The values given in parentheses are provided for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations before use.