SAE AS 1132H-2008 螺栓、螺钉和螺母.英制外部扳紧UNJ螺纹.设计标准被谁引用

标准号: SAE AS 1132H-2008
发布日期: 2008年10月17日
实施日期
废止日期: 无
中国标准分类号: V20
国际标准分类号: 49.030.10;49.030.30
发布单位: US-SAE
引用标准: ASME B46.1-2002 ASME Y14.5M-1994 ASME Y14.36M-1996 SAE AS 870 SAE AS 3062C-1979 SAE AS 3063B-1996 SAE AS 5443-1999 SAE AS 8879-1996
被代替标准: SAE AS 1132G-2004

适用范围: The scope of this standard is to define the following dimensional requirements for double hexagon, hexagon head and tee headed bolts, and nuts having a minimum tensile strength ranging up to 220 ksi, unless otherwise specified. a. Head dimensions (see 3.1); b. shank dimensions (see 3.2); c. geometric control (see 3.3); d. surface texture (see 3.4); and e. dimensions for nuts (see Section 4). For design calculations the SAE AS 8879 coarse threads, UNJC, shall be used for 0.164 thread sizes, and for smaller thread sizes use fine threads, UNJF. For particulars of thread runout and lead threads for bolts, see SAE AS 3062. NOTE. The ability of a design to achieve a given strength class will ultimately depend on the selected material and the associated processing To establish design requirements for bolts, screws and nuts in the UNJ thread inch series primarily for use on propulsion systems. As defined by the Federal Cataloging System, thread sizes less than 0.190 are referred to as screws and larger sizes are referred to as bolts. For the purpose of this document, the term bolt will be used for all sizes.

SAE AS 1132H-2008
螺栓、螺钉和螺母.英制外部扳紧UNJ螺纹.设计标准