ACI 524R-2008
以石膏为基础的波特兰水泥指南

Guide to Portland Cement-Based Plaster

ACI 524R-2008 发布历史

Exterior insulation and finish systems (EIFS) are exterior wall-cladding systems that consist of an insulation board covered with an integrally reinforced base coat and a textured protective finish coat. Portland cement may be used in these systems, but their application and suitability are not covered in this guide. Exterior Insulation and Finish Systems Design Handbook (Robert 1997) provides useful information on this class of product. The use of one-coat portland cement-based plastering systems and other such proprietary portland cement-based systems are acknowledged; however, they are beyond the scope of this document, which addresses only traditional two-coat or three-coat portland cement-based plastering systems. Alternative nontraditional and proprietary portland cement-based plastering systems are addressed in special reports, such as those written by the International Code Council (ICC Evaluation Service, Inc. 2006). One-coat systems and other proprietary systems typically rely on a proven performance history within the environment and region they are intended to be used and, where required by code, proprietary products may have special approval via a published Evaluation Services Report that specifies the installation procedure and allowed locations for its use. Swimming pool plastering is considered an alternative nontraditional form of portland cement-based plastering in this guide. While many aspects of this guide are relevant to swimming pool plastering, information specific to swimming pool plastering can be found in reports by the Portland Cement Association’s Portland Cement Plaster/Stucco Manual and the National Plasterers Council’s Technical Manual.

ACI 524R-2008由美国混凝土学会 US-ACI 发布于 2008-08-01。

ACI 524R-2008 在中国标准分类中归属于: Q11 水泥。

ACI 524R-2008 发布之时，引用了标准

• ACI 232.1R *， 2012-07-01 更新
• ACI 308R *， 2016-05-01 更新
• ACI 515.1R 
• ACI 546R *， 2014-09-01 更新
• ASTM C897 现场拌制的硅酸盐水泥基灰泥骨料的标准规格*， 2022-07-22 更新
• ASTM C926 硅酸盐水泥基灰泥应用的标准规范
• ASTM C932 外部抹灰用表面用粘合剂的标准规范
• ASTM C933 焊接钢丝绳标准规范
• ASTM C979 整体彩色混凝土颜料标准规范
• ASTM C989 混凝土和灰浆用磨细高炉矿渣的标准规范
• ASTM C1032 编织电线基座标准规格
• ASTM C1059 粘合新鲜硬化混凝土的胶乳剂标准规范
• ASTM C1063 用于接收内部和外部波特兰水泥基膏体的板条和毛边安装标准规范
• ASTM C1116 ASTM C1116-2010a(R2015)
• ASTM C1157 *， 2022-07-22 更新
• ASTM C1324 硬化砖石砂浆的检验和分析标准试验方法
• ASTM C1328 塑性(灰泥)水泥的标准规范*， 2022-07-22 更新
• ASTM C1329 砂浆水泥的标准规范*， 2022-07-22 更新
• ASTM D98 氯化钙标准规范
• ASTM D4258 涂料表面清洁混凝土的标准做法
• ASTM D4259 磨损混凝土的标准实践*， 2012-05-01 更新
• ASTM D4261 涂层用表面清洁混凝土砌块的标准实施规程
• ASTM D4262 化学清洗或蚀刻混凝土表面pH值的标准试验方法

* 在 ACI 524R-2008 发布之后有更新，请注意新发布标准的变化。

ACI 524R-2008的历代版本如下：

• 2004年06月28日 ACI 524R-2004
• 2008年08月01日 ACI 524R-2008 以石膏为基础的波特兰水泥指南
• 2016年03月01日 ACI 524R-2016

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ACI 524R-2008 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ACI 524R-2008

发布日期

2008年08月01日

实施日期

废止日期

无

中国标准分类号

Q11

发布单位

US-ACI

引用标准

ACI 232.1R ACI 308R ACI 515.1R ACI 546R ASTM C897 ASTM C926 ASTM C932 ASTM C933 ASTM C979 ASTM C989 ASTM C1032 ASTM C1059 ASTM C1063 ASTM C1116 ASTM C1116M ASTM C1157 ASTM C1324 ASTM C1328 ASTM C1329 ASTM D98 ASTM D4258 ASTM D4259 ASTM D4261 ASTM D4262 AS

被代替标准

ACI 524R-2004

适用范围

Exterior insulation and finish systems (EIFS) are exterior wall-cladding systems that consist of an insulation board covered with an integrally reinforced base coat and a textured protective finish coat. Portland cement may be used in these systems, but their application and suitability are not covered in this guide. Exterior Insulation and Finish Systems Design Handbook (Robert 1997) provides useful information on this class of product. The use of one-coat portland cement-based plastering systems and other such proprietary portland cement-based systems are acknowledged; however, they are beyond the scope of this document, which addresses only traditional two-coat or three-coat portland cement-based plastering systems. Alternative nontraditional and proprietary portland cement-based plastering systems are addressed in special reports, such as those written by the International Code Council (ICC Evaluation Service, Inc. 2006). One-coat systems and other proprietary systems typically rely on a proven performance history within the environment and region they are intended to be used and, where required by code, proprietary products may have special approval via a published Evaluation Services Report that specifies the installation procedure and allowed locations for its use. Swimming pool plastering is considered an alternative nontraditional form of portland cement-based plastering in this guide. While many aspects of this guide are relevant to swimming pool plastering, information specific to swimming pool plastering can be found in reports by the Portland Cement Association’s Portland Cement Plaster/Stucco Manual and the National Plasterers Council’s Technical Manual.