1.1
This Code applies to the installation of
(a) appliances, equipment, components, and accessories where gas is to be used for fuel purposes;
(b) piping and tubing systems extending from the termination of the utility installation or from the
distributor’s propane tank;
(c) vehicle-refuelling appliances and associated equipment meeting the requirements of a
general-purpose appliance to fill a natural-gas-fuelled vehicle; and
(d) stationary gas engines and turbines.
1.2
This Code does not apply to
(a) marine or pipeline terminals;
(b) petroleum refineries;
(c) gas where used as a feedstock in chemical plants;
(d) utility pipeline distribution and transmission pipelines;
(e) storage and handling of liquefied natural gas or underground reservoirs for natural gas;
(f) the installation of NGV fuel systems, containers, and refuelling stations;
(g) the storage and utilization of compressed natural gas on boats;
(h) the installation of vehicle-refuelling appliances when NGV storage containers are installed as part of
the system;
(i) refrigerated storage or underground reservoirs for propane;
(j) propane used on boats;
(k) propane used as a propellant in aerosol containers;
(l) butane fuel cylinders of 150 g capacity or less; and
(m) the installation of containers and equipment to be used for propane in distribution locations and
filling plants and on tank trucks, tank trailers, and cargo liners.
1.3
Where the term “gas” is used, the requirements of this Code include, and apply equally to, any of the
following gases or mixtures of them: natural gas, manufactured gas, or mixtures of propane gas and air,
propane, propylene, butanes (normal butane or isobutane), and butylenes.
1.4
This Code and any Standards referenced in it do not make or imply any assurance or guarantee with
respect to the life expectancy, durability, or operating performance of equipment and materials
referenced in the Code.
1.5
The values given in yard/pound units are the standard. This Code contains SI (metric) equivalents to
yard/pound units so that the Code can be used in SI (metric) units. SI (metric) equivalents may be
approximate.
1.6
In this Code, unless approved otherwise by the authority having jurisdiction, “shall” indicates a
mandatory requirement; “should” indicates a recommendation or that which is advised but not
mandatory; “may” indicates an advisory or optional statement. Notes to the text do not include
mandatory or alternative requirements. The purpose of a note is to separate from the text explanatory or
informative material that is not properly a part of this Code. Notes to figures and tables, however, are
considered part of the figure or table and are written as mandatory requirements. Legends to figures are
also written as mandatory requirements.