ASTM E1457-2007e3
测量金属蠕变开裂增长次数的标准试验方法

Standard Test Method for Measurement of Creep Crack Growth Times in Metals

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 ASTM E1457-2007e3 前三页，或者稍后再访问。

如果您需要购买此标准的全文，请联系： 。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

ASTM E1457-2007e3

发布日期

2007年

实施日期

废止日期

无

中国标准分类号

H22

国际标准分类号

77.040.10 (Mechanical testing of metals)

发布单位

US-ASTM

适用范围

Creep crack growth rate expressed as a function of the steady state C* or K characterizes the resistance of a material to crack growth under conditions of extensive creep deformation or under brittle creep conditions. Background information on the rationale for employing the fracture mechanics approach in the analyses of creep crack growth data is given in (8, 10, 27-32).

Aggressive environments at high temperatures can significantly affect the creep crack growth behavior. Attention must be given to the proper selection and control of temperature and environment in research studies and in generation of design data.

Expressing CCI time, t_0.2 and CCG rate, da/dt as a function of an appropriate fracture mechanics related parameter, as discussed in 11.8 generally provides results that are independent of specimen size and planar geometry for the same stress state at the crack tip for the range of geometries and sizes presented in this document (see Annex A1). Thus, the appropriate correlation will enable exchange and comparison of data obtained from a variety of specimen configurations and loading conditions. Moreover, this feature enables creep crack growth data to be utilized in the design and evaluation of engineering structures operated at elevated temperatures where creep deformation is a concern. The concept of similitude is assumed, implying that cracks of differing sizes subjected to the same nominal C*(t), C_t, or K will advance by equal increments of crack extension per unit time, provided the conditions for the validity for the specific crack growth rate relating parameter are met. See 11.7 for details.

The effects of crack tip constraint arising from variations in specimen size, geometry and material ductility can influence t_0.2 and da/dt. For example, crack growth rates at the same value of C*(t), C_t in creep-ductile materials generally increases with increasing thickness. It is therefore necessary to keep the component dimensions in mind when selecting specimen thickness, geometry and size for laboratory testing.

Different geometries as mentioned in 1.1.6 may have different size requirements for obtaining geometry and size independent creep crack growth rate data. It is therefore necessary to account for these factors when comparing da/dt data for different geometries or when predicting component life using laboratory data. For these reasons, the scope of this standard is restricted to the use of specimens shown in Annex A1 and the validation criteria for these specimens are specified in 11.2.3 and 11.7. However if specimens other than the C(T) geometry are used for generating creep crack growth data, then the da/dt data obtained should, if possible, be compared against test data derived from the standard C(T) tests in order to validate the data.

Creep cracks have been observed to grow at different rates at the beginning of tests compared with the rates at equivalent C*(t), C_t or K values for cracks that have sustained previous creep crack extension (9, 10). This region is identified as x2018;tailx2019;. The duration of this transient condition, x2018;tailx2019;, varies with material and initially applie..........