BS DD CEN/TS 16115-1:2011
环境空气质量.生物气溶胶的测量.使用过滤器抽样系统和培养基分析的霉菌测定

Ambient air quality. Measurement of bioaerosols. Determination of moulds using filter sampling systems and culture-based analyses

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 BS DD CEN/TS 16115-1:2011 前三页，或者稍后再访问。

您也可以尝试购买此标准，
点击右侧 “购买” 按钮开始采购（由第三方提供）。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

BS DD CEN/TS 16115-1:2011

发布

2011年

发布单位

英国标准学会

当前最新

BS DD CEN/TS 16115-1:2011

 

 

引用标准

EN ISO 8199:2007

适用范围

This Technical Specification describes the measurement of moulds in ambient air in order to identify, quantify and characterize bioaerosol pollution in ambient air resulting from emissions from different sources. The method described specifies the sampling of moulds as part of the suspended particulate matter (SPM, here particles with aerodynamic diameter up to ca. 30 μm) using a filter sampling system with gelatine/polycarbonate filter combination followed by the culture-based analyses on DG18 agar. The sampling duration can be varied between 10 min to 24 h. The health effect of bioaerosols is not limited to any particle fraction, therefore, this document describes the sampling of moulds as part of the suspended particulate matter as a convention method. NOTE The sampling method described in this document in principle is likely to be appropriate for the sampling of actinomycetes and other spore-forming bacteria (resistant to desiccation). For these species a special analytical procedure using different culture media should be applied, but this is not within the scope of this document. The standard method set out in this Technical Specification is accepted by convention as reference method. The measured quantity, here the number of colony forming units per cubic meter (CFU/m), is determined by the inlet design of the sampling head, the associated operational parameters and the analytical procedure. Standardized methods for sampling, detection and enumeration of moulds including standards for sampling strategies are important for comparative assessment of moulds in ambient air. Before doing any measurements a plan for the measurement strategy is necessary (see CEN/TS 16115-2 [5]). WARNING — The use of this Technical Specification may involve hazardous materials, operations and equipment. This Technical Specification does not purport to address all the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

BS DD CEN/TS 16115-1:2011相似标准

推荐

BS DD CEN/TS 16115-1:2011 中可能用到的仪器设备