ASTM F1945-05(2011)
测定曝露于室内荧光照明和室外透进日光下的喷墨打印制品耐晒性的标准操作规程
Standard Practice for Determining the Lightfastness of Ink Jet Prints Exposed to Indoor Fluorescent Lighting
- 标准号
- ASTM F1945-05(2011)
- 发布
- 2005年
- 发布单位
- 美国材料与试验协会
- 当前最新
- ASTM F1945-05(2011)
- 引用标准
- ASTM D1729 ASTM D2244 ASTM D3424 ASTM D4674 ASTM G113 ASTM G141 ASTM G151 ASTM G154
- 代替标准
- LST EN 13379-2001+A1-2013
- 适用范围
- 5. Significance and UseTop
Bottom 5.1 Lightfastness of printed ink jet media for specified periods of time is pertinent to the end use of these materials. Since the ability of ink jet prints to withstand color changes is a function of the spectral power distribution of the light source to which it is exposed, it is important that lightfastness be assessed under the conditions appropriate to the end use application. While ink jet prints may be handled and displayed under a variety of conditions, this practice is intended to produce the color changes that may occur in ink jet prints upon exposure to irradiation from office lighting where overhead fluorescent light is used for illumination by simulating these conditions.
5.2 The accelerated procedures covered in this practice are intended to provide a means for the rapid evaluation of the relative lightfastness of a series of prints or of a print of interest in comparison to the performance of controls with known lightfastness exposed simultaneously under laboratory conditions. Test results are useful for specification acceptance between producer and user, for quality control, and for research and product development.
Note 1???Refer to Practice G151 for full cautionary guidance applicable to all laboratory weathering devices. Additional information on sources of variability and on strategies for addressing variability by design and data analysis of laboratory accelerated exposure tests is found in Guide G141.5.3 Variation in results may be expected when operating conditions are varied within the accepted limits of this practice. For example, differences in the level of irradiance using lamps with the same spectral power distribution can cause significant differences in test results. Therefore, no reference to the use of this practice should be made unless accompanied by a report prepared in accordance with Section 12 which specifies whether Test Method D4674 Method II or Method III was used and which describes the specific operating conditions used.
Note 2???A comparison of the two listed methods has not been performed. Therefore, the two methods cannot be considered to give equivalent test results unless tests have been carried out to show that the two methods provide the same stability rankings, i.e., the same relative stabilities for different ink jet prints. Also, exposure times for equivalent changes in color and optical densities by the two methods has not been determined.5.4 Reproducibility of test results between laboratories using the same method (e.g., Method II or Method III of Test Method
Copyright ©2007-2022 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证：京ICP证110310号