ASTM D955-2008(2014)
测量热塑性塑料模型尺寸收缩率的标准试验方法

Standard Test Method of Measuring Shrinkage from Mold Dimensions of Thermoplastics


 

 

非常抱歉,我们暂时无法提供预览,您可以试试: 免费下载 ASTM D955-2008(2014) 前三页,或者稍后再访问。

如果您需要购买此标准的全文,请联系:

点击下载后,生成下载文件时间比较长,请耐心等待......

 

标准号
ASTM D955-2008(2014)
发布日期
2008
实施日期
废止日期
中国标准分类号
G31
国际标准分类号
83.140.10 (Films and sheets)
发布单位
US-ASTM
适用范围

5.1x00a0;Injection Moldingx2014;In injection molding, the difference between the dimensions of a mold cavity and of the molded specimen may vary according to the design of the mold and operation of the molding process. Factors such as mold and melt temperature, fill times, and packing conditions are known to affect shrinkage significantly. Adherence to the specified mold design (see 7.1) and specifications outlined in Practice D3641 or ISO 294-4 or the appropriate material specification will improve the reproducibility of the test.

5.2x00a0;Compression Moldingx2014;In compression molding, the difference between the dimensions of a mold cavity and of the molded specimen may vary according to the design of the mold and operation of the molding process. Factors, such as the amount of material in charge, cooling time, and pressure application are known to affect shrinkage significantly. Adherence to the specified mold design (see 7.2) and specifications outlined in Practice D4703 or ISO 293 or the appropriate material specifications will improve the reproducibility of the test.

1.1x00a0;This test method is intended to measure shrinkage from mold cavity to molded dimensions of thermoplastics when molded by compression or injection processes with specified process conditions.

1.2x00a0;This test method covers shrinkage measurements at 24 and 48 hours.

1.3x00a0;This method will give comparable data based on standard specimens and can not predict absolute values in actual molded parts with varying flow paths, wall thicknesses, pressure and temperature gradients and process conditions. Differences in mold shrinkage may also be observed among the three specimen geometries described in this test method.

1.4x00a0;The values stated in SI units are to be regarded as the standard. The values given in parentheses are given for information only.

1.5x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1:x00a0;This standard and ISO 294-3 are equivalent in the design of specimen D2. This test method is equivalent to ISO 294-4 where Type D2 specimens and the procedure in Appendix X2 are used.





Copyright ©2007-2016 ANTPEDIA, All Rights Reserved
京ICP备07018254号 京公网安备1101085018 电信与信息服务业务经营许可证:京ICP证110310号