ASTM C42/C42M-16
混凝土钻取试样和锯取试样的制备和试验用标准试验方法

Standard Test Method for Obtaining and Testing Drilled Cores and Sawed Beams of Concrete

被代替

标准号

ASTM C42/C42M-16

发布

2016年

发布单位

美国材料与试验协会

替代标准

ASTM C42/C42M-18

当前最新

ASTM C42/C42M-20

 

 

引用标准

ASTM C1231/C1231M ASTM C1542/C1542M ASTM C1604/C1604M ASTM C174/C174M ASTM C39/C39M ASTM C496/C496M ASTM C617/C617M ASTM C642 ASTM C670 ASTM C78/C78M ASTM C823/C823M

适用范围

3.1 This test method provides standardized procedures for obtaining and testing specimens to determine the compressive, splitting tensile, and flexural strength of in-place concrete.

3.2 Generally, test specimens are obtained when doubt exists about the in-place concrete quality due either to low strength test results during construction or signs of distress in the structure. Another use of this method is to provide strength information on older structures.

3.3 Concrete strength is affected by the location of the concrete in a structural element, with the concrete at the bottom tending to be stronger than the concrete at the top. Core strength is also affected by core orientation relative to the horizontal plane of the concrete as placed, with strength tending to be lower when measured parallel to the horizontal plane.3 These factors shall be considered in planning the locations for obtaining concrete samples and in comparing strength test results.

3.4 The strength of concrete measured by tests of cores is affected by the amount and distribution of moisture in the specimen at the time of test. There is no standard procedure to condition a specimen that will ensure that, at the time of test, it will be in the identical moisture condition as concrete in the structure. The moisture conditioning procedures in this test method are intended to provide reproducible moisture conditions that minimize within-laboratory and between-laboratory variations and to reduce the effects of moisture introduced during specimen preparation.

3.5 The measured compressive strength of a core will generally be less than that of a corresponding properly molded and cured standard cylinder tested at the same age. For a given concrete, however, there is no unique relationship between the strengths of these two types of specimens (see Note 3). The relationship is affected by many factors such as the strength level of the concrete, the in-place temperature and moisture histories, the degree of consolidation, batch-to-batch variability, the strength-gain characteristics of the concrete, the condition of the coring apparatus, and the care used in removing cores.

Note 3: A procedure is available for estimating the equivalent cylinder strength from a measured core strength.4

Note 4: In the absence of core strength requirements of an applicable building code or of other contractual or legal documents that may govern the project, the specifier of tests should establish in the project specifications the acceptance criteria for core strengths. An example of acceptance criteria for core strength is provided in ACI 318,5 which are used to evaluate cores taken to investigate low strength test results of standard-cured cylinder during construction. According to ACI 318, the concrete represented by the cores is considered structurally adequate if the average strength of three cores is at......

ASTM C42/C42M-16相似标准

推荐

谁引用了ASTM C42/C42M-16 更多引用