DS/ISO 6133-1981
橡胶和塑料. 测定撕裂强度和粘合强度时获得的多峰值曲线的分析

Rubber and plastics. Analysis of multi-peak traces obtained in determinations of tear strength and adhesion strength

DS/ISO 6133-1981 发布历史

This International Standard specifies three methods of calculating, after testing, the tear strength and adhesion strength of vulcanized rubber or fabrics coated with or adhered to rubber or plastics. The results are calculated by determining the median and range of peak values from a graphical plot of f.prce versus time recorded during the test. A trace for an adhesion strength test or tear strength test may show few or many force peaks, depending on the material under investigation. The choice of the method of calculation depends on the number of peaks in the trace. The purpose of this International Standard is to obtain more uniformity in the evaluation and presentation of test results, It is applicable only, however, when specified in another Interna-tional Standard, i.e. a method of test or a specification. For other details, such as apparatus, test piece preparation, conditioning, procedure, etc, requirements given in the relevant International Standard shall apply. NOTE — In certain cases the methods of analysis given may not be adequate, for example for peak values showing a trend with time. In cases where the minimum force values are of interest, it is possible to use the same methods of calculation as when determining from a range of peak values.

DS/ISO 6133-1981由丹麦标准化协会 DK-DS 发布于 1981。

DS/ISO 6133-1981的历代版本如下：

• 1981年 DS/ISO 6133-1981 橡胶和塑料. 测定撕裂强度和粘合强度时获得的多峰值曲线的分析

非常抱歉，我们暂时无法提供预览，您可以试试： 免费下载 DS/ISO 6133-1981 前三页，或者稍后再访问。

注意： 点击下载后，生成下载文件时间比较长，请耐心等待......

标准号

DS/ISO 6133-1981

发布日期

1981年

实施日期

废止日期

无

国际标准分类号

825

发布单位

DK-DS

适用范围

This International Standard specifies three methods of calculating, after testing, the tear strength and adhesion strength of vulcanized rubber or fabrics coated with or adhered to rubber or plastics. The results are calculated by determining the median and range of peak values from a graphical plot of f.prce versus time recorded during the test. A trace for an adhesion strength test or tear strength test may show few or many force peaks, depending on the material under investigation. The choice of the method of calculation depends on the number of peaks in the trace. The purpose of this International Standard is to obtain more uniformity in the evaluation and presentation of test results, It is applicable only, however, when specified in another Interna-tional Standard, i.e. a method of test or a specification. For other details, such as apparatus, test piece preparation, conditioning, procedure, etc, requirements given in the relevant International Standard shall apply. NOTE — In certain cases the methods of analysis given may not be adequate, for example for peak values showing a trend with time. In cases where the minimum force values are of interest, it is possible to use the same methods of calculation as when determining from a range of peak values.