GB/T 1800.2-2009
Geometrical Product Specifications (GPS) Limits and fits--Part 2:Tables of standard tolerance grades and limit deviations for holes and shafts (English Version)

Standard No.

GB/T 1800.2-2009

Language

Chinese, Available in English version

Release Date

2009

Published By

General Administration of Quality Supervision, Inspection and Quarantine of the People‘s Republic of China

Status

Be replaced 2020-11

Replace By

GB/T 1800.2-2020

Latest

GB/T 1800.2-2020

Replace

GB/T 1800.4-1999

Scope

This part of GB/T 1800 stipulates the limit deviation value of the common tolerance zone of holes and shafts, and its value is calculated according to the standard tolerance and basic deviation value table in GB/T 1800.1. It includes the upper limit deviation ES of the hole and the upper limit deviation es of the shaft, the lower limit deviation EI of the hole and the lower limit deviation ei of the shaft (see Figure 1). This standard applies to the dimensional elements of cylindrical and non-cylindrical smooth workpieces.

GB/T 1800.2-2009 Referenced Document

• GB/T 1800.1-2009 Gemetrical Product Specifications(GPS).Limits and fits.Part 1:Bases of tolerances,deviations and fits
• GB/T 1801-2009 Gemetrical Product Specifications(GPS).Limits and fits.Selection of tolerance zones and fits
• GB/Z 20308-2006 Geometrical product specifications(GPS). Masterplan

GB/T 1800.2-2009 history

• 2020 GB/T 1800.1-2020 Geometrical product specifications (GPS)—ISO code system for tolerances on linear sizes—Part 1: Basis of tolerances, deviations and fits
• 2009 GB/T 1800.1-2009 Gemetrical Product Specifications(GPS).Limits and fits.Part 1:Bases of tolerances,deviations and fits
• 1997 GB/T 1800.1-1997 Limits and fits--Based--Part 1: Terminology
• 1980 GB/T 1800-1979 General Tolerance and Fit Standard Tolerance and Basic Deviation

GB/T 1800.2-2009 Geometrical Product Specifications (GPS) Limits and fits--Part 2:Tables of standard tolerance grades and limit deviations for holes and shafts has been changed from GB/T 1800.4-1999 Limits and fits Tables of standard tolerance grades and limit deviations for holes and shafts.

GB/T 1800.2-2009 -All Parts