13.030.20 液态废物、淤泥 标准查询与下载

BS EN 14701-2:2006 淤泥特性.过滤性能.第2部分：过滤比电阻的测定

This document specifies a method for determining the specific resistance to filtration of sludges, conditioned or non-conditioned. This document is applicable to sludges and sludge suspensions from: ? storm water handling; ? urban wastewater collecting systems; ? urban wastewater treatment plants; ? treating industrial wastewater similar to urban wastewater (as defined in Directive 91/271/EEC); ? water supply treatment plants; This method is also applicable to sludge and sludge suspensions of other origins.

Characterization of sludges - Filtration properties - Part 2: Determination of the specific resistance to filtration

BS EN 14701-2:2007 污泥的特性描述 过滤性能 过滤比阻的测定

Characterization of sludges - Filtration properties - Determination of the specific resistance to filtration

PD CEN/TR 15463:2007 污泥的特性.物理一致性.触变行为和堆积行为

Characterization of sludges - Physical consistency - Thixotropic behaviour and piling behaviour

PD CEN/TR 15473:2007 淤泥的特性.淤泥烘干用良好实施规程

This CEN Technical report describes good practices for sludge drying and it is one of a series on sludge management options. It gives guidance on drying processes; characteristics of dried sludge products; recycling or disposal of dried sludge products. from urban wastewater treatment plants. Sludges of other origin, like sludge from water supply or industrial treatment plants are not inThe exact scope of this CEN Technical Report, howeverThe handling of most of these sludges will comply to a large extent withThe leads given inThis CEN Technical Report.

Characterization of sludges - Good practice for sludges drying

ASTM F2363-06 美国海岸警卫队II型或IMO MARPOL73/78附件IV海洋卫生设备（直通式处理）标准规范

1.1 This specification covers the design, manufacture, performance, operation, functioning, and testing of USCG Type II Marine Sanitation Device or IMO MARPOL 73/78 Annex IV flow through treatment device intended to process sewage and graywater generated during the ship''s normal service. This specification is intended for use by purchasers, designers, and manufacturers of shipboard environmental pollution control equipment to determine the requirements for equipment purchase, equipment use, and design considerations.1.2 The device shall be capable of meeting the effluent requirements detailed in Table 1 with respect to ship''s operational area.

Standard Specification for United States Coast Guard Type II or IMO MARPOL 73/78 Annex IV Marine Sanitation Devices (Flow Through Treatment)

DS/EN 14702-2:2006 污泥的表征 沉降特性 第2部分：增稠性的测定

This document specifies a method for the determination of the thickenability of sludge suspensions. This document is applicable to sludge suspensions from:- storm water handling;- urban wastewater collecting systems;- urban wastewater treatment plants;- treating industrial wastewater similar to urban wastewater (as defined in Directive 91/271 EEC);- water supply treatment plants.This method is also applicable to sludge suspensions from other origin.

Characterisation of sludges - Settling properties - Part 2: Determination of thickenability

DS/CEN/TR 15175:2006 污泥的特性 组织和进行污泥化学和微生物分析方法实验室间试验的规程

This Technical Report specifies the requirements for interlaboratory tests to validate chemical and microbiological methods for sludges.

Characterization of sludges - Protocol for organizing and conducting inter-laboratory tests of methods for chemical and microbiological analysis of sludges

LST EN 14701-2-2006 污泥的表征 过滤性能 第2部分：特定过滤阻力的测定

Characterization of sludges - Filtration properties - Part 2: Determination of the specific resistance to filtration

LST EN 14671-2006 污泥的表征 使用 2 mol/l 氯化钾测定可萃取氨的预处理

Characterization of sludges - Pre-treatment for the determination of extractable ammonia using 2 mol/l potassium chloride

LST EN 14701-3-2006 污泥的表征 过滤性能 第3部分：可压缩性的测定

Characterization of sludges - Filtration properties - Part 3: Determination of the compressibility

DIN EN 14671:2006 污泥的特性.2摩尔/升氯化钾测定可萃取氨的预处理

This European standard specifies a procedure for the determination of extractable ammonia using 2 mol/l potassium chloride solution in raw and digested sewage sludges. The range of the method is up to 100 g/kg N assuming appropriate dilution of the potassium chloride extract in the final measurement step.

Characterization of sludges - Pre-treatment for the determination of extractable ammonia using 2 mol/l potassium chloride English version of DIN EN 14671:2006-09

DIN EN 14701-3:2006 污物特性.过滤特性.第3部分:压缩性的测定

This European standard specifies a method to determine the compressibility of sludges, conditioned or not. This document is applicable to sludges and sludge suspensions from storm water handling, urban wastewater collecting systems, urban wastewater treatment plants, treating industrial wastewater similar to urban wastewater (as defined in Directive 91/271/EEC), and water supply treatment plants. This method is also applicable to sludge and sludge suspensions of other origin.#,,#

Characterization of sludges - Filtration properties - Part 3: Determination of the compressibility English version of DIN EN 14701-3:2006-09

DS/CEN/TR 15252:2006 污泥的表征 污泥物理特性验证方法的协议

This Technical Report specifies procedures for validating characterization methods for physical properties of sludge.This Technical Report is applicable to sludge and sludge suspensions from:- storm water handling;- urban wastewater collecting systems;- urban wastewater treatment plants;- treating industrial wastewater similar to urban wastewater (as defined in Directive 91/271/EEC);- water supply treatment plants.This method is also applicable to sludge suspensions from other origin.

Characterization of sludges - Protocol for validating methods for physical properties of sludges

DS/EN 14701-1:2006 污泥的特性 过滤特性 第1部分：毛细管抽吸时间（CST）

This document specifies a method for the determination of the capillary suction time. This document is applicable to sludge and sludge suspensions from:- storm water handling;- urban wastewater collecting systems;- urban wastewater treatment plants;- treating industrial wastewater similar to urban wastewater (as defined in Directive 91/271/EEC);- water supply treatment plants.This method is also applicable to sludge suspensions from other origin.

Characterisation of sludges - Filtration properties - Part 1: Capillary suction time (CST)

DS/EN 14671:2006 污泥的表征 使用 2 mol/l 氯化钾测定可萃取氨的预处理

This European standard specifies a procedure for the determination of extractable ammonia using a 2 mol/l potassium chloride solution in raw and digested sewage sludges. The range of the method is up to 100 g/kg N assuming appropriate dilution of the potassium chloride extract in the final measurement step. The above wording will be modified once the round robin results are available. It may be suitable for other types of sludges, but the user should validate the method using these sludges.

Characterization of sludges - Pre-treatment for the determination of extractable ammonia using 2 mol/l potassium chloride

DS/EN 14701-3:2006 污泥的表征 过滤性能 第3部分：可压缩性的测定

This document specifies a method to determine the compressibility of sludges, conditioned or not.This document is applicable to sludges and sludge suspensions from: storm water handling; urban wastewater collecting systems; urban wastewater treatment plants; treating industrial wastewater similar to urban wastewater (as defined in Directive 91/271/EEC); water supply treatment plants.This method is also applicable to sludge and sludge suspensions of other origin.

Characterization of sludges - Filtration properties - Part 3: Determination of the compressibility

DS/EN 14702-1:2006 污泥的表征-沉降特性-第1部分：沉降性的测定（污泥体积比例和污泥体积指数的测定）

This document specifies a method for the determination of the settleability of sludge suspensions. This document is applicable to sludge suspensions from:- storm water handling;- urban wastewater collecting systems;- urban wastewater treatment plants;- treating industrial wastewater similar to urban wastewater (as defined in Directive 91/271 EEC);- water supply treatment plants.This method is also applicable to sludge suspensions from other origin.

Characterisation of sludges - Settling properties - Part 1: Determination of settleability (Determination of the proportion of sludge volume and sludge volume index)

DS/CEN/TR 14742:2006 污泥的特性 实验室化学调节程序

This Technical Report specifies a procedure for the chemical conditioning in laboratory of sludges.This Technical Report is applicable to sludges and sludge suspensions from:- storm water handling;- urban wastewater collecting systems;- urban wastewater treatment plants;- treating industrial wastewater similar to urban wastewater (as defined in Directive 91/271/EEC);- water supply treatment plants.This method is applicable to sludge and sludge suspensions of other origin

Characterization of sludges - Laboratory chemical conditioning procedure

BS EN 14672:2005 淤泥的特性.磷总含量的测定

This European Standard specifies a procedure for complete digestion of raw/digested sludge, suitable for the subsequent determination of phosphorus. NOTE Phosphorus in environmental samples can be present in many forms. This method of pre-treatment enables the analyst to determine all forms - i.e. total phosphorus, by quantitative oxidation yielding an aqueous solution of orthophosphate which should be analysed for phosphate according to method EN ISO 6878, EN ISO 10304-2 or an equivalent validated method. The range of the method is up to 50 g/kg P assuming appropriate dilution of the digest in the final measurement step.

Characterization of sludges - Determination of total phosphorous

NF X33-026-1*NF EN 14701-1:2006 淤泥特征.过滤特性.第1部分:毛细管吸入时间(CST)

Characterization of sludges - Filtration properties - Part 1 : capillary suction time (CST).