13.220.99 有关消防的其他标准 标准查询与下载

NF S62-302:2003 烟雾和热气的控制系统.第2部分:烟雾和热气排气口用自然通风机规范

Smoke and heat control systems - Part 2 : specification for natural smoke and heat exhaust ventilators.

DIN EN 12101-2:2003 烟和热控制系统.第3部分:烟和热的自然排放通风器规范

This Part of this European Standard specifies requirements and gives test methods for natural smoke and heat exhaust ventilators which are intended to be installed as a component of a natural smoke and heat exhaust system conforming to prEN 12101-4 and prEN 12101-5.

Smoke and heat control systems - Part 2: Specification for natural smoke and heat exhaust ventilators; German version EN 12101-2:2003

BS EN 12101-2:2003 烟和热控制系统.烟和热的自然排放通风机规范

This part of this European Standard specifies requirements and gives test methods for natural smoke and heat exhaust ventilators which are intended to be installed as a component of a natural smoke and heat exhaust system.

Smoke and heat control systems - Specification for natural smoke and heat exhaust ventilators

DIN 18232-2:2003 排烟排热控制系统.第2部分:自然排烟和排热通风机.设计、要求和安装

This standard is applicable to the design and installation of natural smoke exhaust ventilators and its components.

Smoke and heat control systems - Part 2: Natural smoke and heat exhaust ventilators; Design, requirements and installation

BS 7990:2003 燃烧排出物中毒性物量测定的管式炉法

To be read in conjunction with BS 7899-1:1997, BS 7899-2:1999

Tube furnace method for the determination of toxic product yields in fire effluents

NF S62-303:2002 烟雾和热气控制系统.第3部分:烟雾和热气排气口用电动通风机规范

Smoke and heat control systems - Part 3 : specification for powered smoke and heat exhaust ventilators.

DIN EN 12101-3:2002 烟和热控制系统.第3部分:动力烟和散热通风机

The document specifies requirements and gives test methods and the approval schedule for a range of ventilators or motors from type test, for powered smoke and heat exhaust ventilators, and their motors which are intended to be installed as part of a powered smoke and heat exhaust ventilation system conforming to prEN 12101-5 and prEN 12101-6 for use in construction works to release smoke and heat in the events of fire. The document specifies the documents covering other components such as ducts, dampers and power supplies.#,,#

Smoke and heat control systems - Part 3: Specification for powered smoke and heat exhaust ventilators; German version EN 12101-3:2002

BS EN 12101-3:2002 烟和热控制系统.烟和热的动力排放通风机规范

This European standard specifies requirements and gives methods for testing powered smoke and heat exhaust ventilators that are intended to be installed as part of a powered smoke and heat exhaust ventilation system. It also provides a procedure for approving a range of powered smoke and heat exhaust ventilators and their motors, from a limited number of tests.

Smoke and heat control systems - Specification for powered smoke and heat exhaust ventilators

ASTM E1412-95 通过被动焦炭被动顶部浓度将火焰残渣样品中的点燃液体残留物分离出来的标准操作

1.1 This practice covers the procedure for removing small quantities of ignitable liquid residue from samples of fire debris using an adsorbent material to extract the residue from the static headspace above the sample, then eluting the adsorbent with a solvent. 1.2 While this practice is suitable for successfully extracting ignitable liquid residues over the entire range of concentration, the headspace concentration methods are best used when a high level of sensitivity is required due to a very low concentration of ignitable liquid residues in the sample. 1.2.1 Unlike other methods of separation and concentration, this practice is essentially nondestructive. 1.3 Alternate separation and concentration procedures are listed in the referenced documents. (see Practices). 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Standard Practice for Separation of Ignitable Liquid Residues from Fire Debris Samples by Passive Headspace Concentration With Activated Charcoal

GSO 637:1996 手动灭火器 第4部分：干粉灭火器

This standard is concerned with portable fire extinguishers, using dry powder as the extinguishing medium.

PORTABLE FIRE EXTINGUISHERS ? PART 4: DRY POWDER FIRE EXTINGUISHERS

CAN/ULC-S520-M91-1991 消防栓标准

1.1 This Standard covers barrel-type hydrants with compression shut-off and slide gate shut-off, for general water works service. 1.2 Hydrants shall be designed for a minimum working pressure of 1000 kPa. 1.3 Hydrants of special design, including those having built-in hose gates, and hydrants designed for higher working pressure are not covered by this Standard. 1.4 Hydrants with replaceable sections or components that are specially designed with lower breaking points than the rest of the unit are not explicitly covered in this Standard. Except for the specially designed breakable sections or components, however, such hydrants shall conform to all other requirements of this Standard. 1.5 This Standard does not cover wet barrel type hydrants. 1.6 References to the setting and drainage of hydrants are not included in this Standard.

Standard for Fire Hydrants

BS 7244:1990 通用消焰器规范

Requirements, test methods for performance and recommendations for appropriate application for flame (deflagration and detonation) arresters, excluding flame arresters for welding equipment covered in BS 6158.

Specification for flame arresters for general use

CNS 10679-1983 木造建筑物防火用水泥砂浆施工法

本标准适用于依第 2.1 节所规定底层之木造建筑物防火用水泥砂浆粉刷施工方法。

Method of Plastering of Cement Mortar for Fire Protection

CNS 10147-1983 屋顶防火检验法

本标准规定建筑物之屋顶〔不含有胸墙短垣（女儿墙）之屋顶〕防火检验法。

Method of Fire Test for Roofs of Buildings

CNS 10148-1983 建筑物木构造部分防火检验法

本标准规定建筑物之墙壁、柱、梁、楼板（含天花板）等木构造部份之防火检验法。

Method of Fire Test for Wooden Structural Parts of Buildings