25.220.01 标准查询与下载

AS 3894.2:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Non-conductive coatings - Continuity testing - Wet sponge method

AS 3894.3:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Determination of dry film thickness

AS 3894.4:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Assessment of degree of cure

AS 3894.5:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Determination of surface profile

AS 3894.6:2002 给水用1/2 In.(12 mm)到2 In.(50 mm)聚乙烯-铝-聚乙烯和交联聚乙烯-铝-交联聚乙烯复合压力管

Site testing of protective coatings - Determination of residual contaminants

HB/Z 5090.2-2001 化学镀镍溶液分析方法 电位滴定法测定次磷酸钠的含量

本标准规定了采用电位滴定法测定化学镀镍溶液中次磷酸钠（NaH2PO2·H2O）含量的方法原理、试剂、仪器、分析步骤及分析结果的计算。 　　本标准适用于化学镀镍溶液中次磷酸钠含量的测定。测量范围：10～25g /L。

Analysis method for electroless nickel plating solution Determination of sodium hypophosphite content through potentiometric titration

HB/Z 5092.3-2001 电镀黑铬溶液分析方法 电位滴定法测定硼酸的含量

本标准规定了采用电位滴定法测定电镀黑铬溶液中硼酸含量的方法原理、试剂、仪器、分析步骤及分析结果的计算。 　　 本标准适用于电镀黑铬溶液中硼酸含量的测定。 测量范围：20～35g/L。

Analytical method of black chromium solution in electroplating Determination of boric acid content by potentiometric titration

HB/Z 5090.1-2001 化学镀镍溶液分析方法 EDTA容量法测定硫酸镍(或氯化镍）的含量

本标准规定了采用EDTA容量法测定化学镀镍溶液中硫酸镍（NiSO4·7H2O）［或氯化镍（NiCl2·6H2O）含量的方法原理、试剂、分析步骤及分析结果的计算。 　　本标准适用于化学镀镍溶液中硫酸镍（或氯化镍）含量的测定。测量范围：NiSO4·7H2O　　　15～40g/L 　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　NiCl2·6H2O　　　15～40g/L

Analysis method for electroless nickel plating solution Determination of nickel sulfate (or nickel chloride) content through EDTA volume method

ASTM B418-01 铸造和锻造电镀锌阳极的标准规范

1.1 This specification covers cast and wrought galvanic zinc anodes for the cathodic protection of more noble metals and alloys in sea water, brackish water, or other saline electrolytes. Type I anodes are most commonly used for such applications. The Type I anode composition in this specification meets the chemical composition requirements of MIL-A-18001J.1.2 Zinc anodes conforming to this specification may be used in other waters, electrolytes, backfills, and soils where experience has shown that the specified composition is efficient and reliable. Type II anodes are most commonly used for such applications.1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

Standard Specification for Cast and Wrought Galvanic Zinc Anodes

JB/T 10242-2001 阴极电泳涂装通用技术规范

JB/T 10242—2001 本标准规定了术语定义，阴极电泳涂装的分类，阴极电泳涂料的选择，阴极电泳涂装的施工及管理，阴极电泳涂装对设备的要求、安全与环保等。 本标准适用于金属工件的阴极电泳涂装。 本标准于2001年5月首次发布。

General technical regulations of cathode electro-coating

SR 7335-11-2001 腐蚀防护．地下金属结构．制造业技术规则

Prezentul standard stabile?te prescrip?iile pentru execu?ia ?i montarea sta?iilor de protec?ie catodic? cu redresor, utilizate pentru protec?ia ?mpotriva coroziunii a construc?iilor metalice ?ngropate.

Protection against corrosion. Underground metalic structures Technical rules for manufacturing and mountage of cathodic protection stations with transformer rectifier

HB/Z 5099.4-2000 电镀银溶液分析方法 电位滴定法测定镀硬银溶液中碳酸钾的含量

本标准规定了采用电位滴定法测定镀硬银溶液中碳酸钾含量的方法原理、试剂、仪器、分析步骤及分析结果的计算。 本标准适用于镀硬银溶液中碳酸钾含量的测定。 测量范围：20～35ｇ/Ｌ。

Analysis method for silver plating solution Determination of potassium carbonate content in hard silver solution through potentiometric titration

HB/Z 5099.7-2000 电镀银溶液分析方法 原子吸收光谱法测定电镀银溶液中铁、铜的含量

本标准规定了采用原子吸收光谱法测定电镀银溶液中铁、铜含量的方法原理、试剂、仪器、分析步骤及分析结果的计算。 本标准适用于电镀银溶液中铁、铜含量的测定。 测量范围：铁≤0.05g/L；铜≤0.05g/L。

Analysis method for silver plating solution Determination of iron, copper contents in silver plating solution through atomic absorption spectrometry

JEDEC JESD22-A100-B-2000 循环的温度潮湿对寿命影响的试验

The Cycled Temperature-Humidity-Bias Life Test is typically performed on cavity packages (e.g. MQUADs, lidded ceramic pin grid arrays, etc.) as an alternative to JESD22-A 10 1 or JESD22-A11 O.

Cycled Temperature-Humidity-Bias Life Test

KS B 4903-1999(2019) 铁和钢的淬火和回火的过程

Process of quenching and tempering of iron and steel

JB/T 8926-1999 火焰喷钼涂层的检验方法

本标准规定了火焰喷钼涂层的检验方法。 本标准适用于火焰喷涂耐磨、抗擦伤等功能性钼涂层，如内燃机活塞环、同步器齿环、拨叉、制动蹄等的火焰喷钼涂层。 本标准也适用于火焰喷涂自粘接性钼涂层。

Test method for flame spraying coating of molybdenum

JB/T 9189-1999 水基材料防锈试验方法.铸铁粉末法

本标准规定了用铸铁粉末测定水基材料防锈性能的试验方法。 本标准适用于水基防锈材料、水基切削液、水基金属清洗材料对黑色金属的防锈性能试验。

Test method for rust preventive of water base materials.Mehtod of cast iron powder

ASTM D5767-95(1999) 用于仪器测量涂层表面光泽度的标准测试方法

Standard Test Methods for Instrumental Measurement of Distinctness-of-Image Gloss of Coating Surfaces

HB/Z 5091.5-1999 电镀铬溶液分析方法 原子吸收光谱法测定铁的含量

本标准规定了采用原子吸收光谱法测定电镀铬溶液中铁含量的方法原理、试剂、仪器、分析步骤及分析结果的计算。 　　本标准适用于电镀铬溶液中铁含量的测定。测量范围：5.00～18.00g/L。

Analysis method for chrome plating solution Determination of ferrous content through atomic absorption spectrometry

HB/Z 5088.2-1999 电镀镍溶液分析方法 沉淀滴定法测定硫酸钠的含量

本标准规定了采用沉淀滴定法测定电镀镍溶液中硫酸钠（Ｎａ２ＳＯ４．１０Ｈ２Ｏ）含量的方法原理、试剂、分析步骤及分析结果的计算。 　　本标准适用于电镀镍溶液中硫酸钠含量的测定。测量范围：４０～９０ｇ／Ｌ

Analysis method for nickel plating solution Determination of sodium sulfate content through precipitation titration