29.240.30 标准查询与下载

CSA C22.2 No.14-1995(R2001) 工控设备

Note: In order to maintain a consistent clause number/subject matter relationship throughout this Standard, some numbers have been purposely omitted. 1. Scope 1.1 This Standard applies to control and protective devices, and accessory devices rated at not more than 1500 V, for starting, stopping, regulating, controlling, or protecting electric motors, generators, heating apparatus, or other equipment that is intended to be installed and used in nonhazardous locations in accordance with the Rules of the Canadian Electrical Code, Part I. Notes: (1) Examples of the industrial control devices covered by this Standard are manual and magnetic starters and controllers; thermal and magnetic overload relays; pushbutton stations (in cluding selector switches and pilot lights); control circuit switches and relays; float-, flow-, pressure-, and vacuum- operated switches; resistors and rheostats; proximity switches; time-delay relays and switches; resistors and rheostats intended for heating and lighting, including those for motor generator fields; and control devices intended for heating and lighting. (2) The term control as used throughout this Standard applies to both starters and controllers. (3) Electrical instruments, such as meters, that may be included as part of control equipment are not covered by this Standard. 1.2 This Standard also applies to assemblies of industrial control and protective devices, and includes motor control centres and assemblies of automatic control and process equipment. 1.3 Certain equipment intended for use with electric elevators, air conditioning and refrigeration equipment, cranes and hoists, electronic and solid-state control equipment, etc, may be subject to additional requirements not included in this Standard.

Industrial Control Equipment

CNS 3990-1995 金属闭锁型配电箱及控制箱（Ａ．Ｃ．３．３─３６ＫＶ）

本标准适用于屋内用及屋外用频率 60Hz 以下，额定电压 3.3 Kv 以上，36kV 以下工厂组立式金属闭锁配电箱及控制箱。备注 1. 本标准对于在可燃性大气中、在矿山、在船舶使用的特殊用途之金属闭锁型配电箱及控制箱，如追加附加性之必要事项亦可适用。2. 本标准对于使用大气压空

A.C. Metal-enclosed Switchgear and Controlgear for Rated Voltages from 3.3 KV to 36 KV

JIS C 8480:1995 低压配电器用箱型开关设备

Box-type switchgear assemblies for low-voltage distribution purpose

UL 916-1994 能源管理设备

Energy management equipment

SNI 04-3582-1994 高压交流电路断路器. 第1部分:范围、条件与定义

High voltage alternating current circuit breaker. Part 1: Scope, condition and definition

BS 7494-2:1993 电力系统远方保护设备性能与测试 模拟比较系统

Gives narrowband and wideband teleprotection systems used to convey analogue information about the primary quantities such as phase or phase and amplitude. The teleprotection equipment can either be separate or integrated in one unit with the protection equipment or the telecommunication equipment.

Performance and testing of teleprotection equipment of power systems. Analogue comparison system

IEC 60834-2:1993 电力系统远方保护设备的性能和试验 第2部分:模拟比较系统

Applies to narrowband (4 kHz bandwidth) and wideband (more than 4 kHz bandwidth) teleprotection systems used to convey analogue information about the primary quantities such as phase or phase and amplitude. The teleprotection equipment can either be sepa

Performance and testing of teleprotection equipment of power systems; part 2: analogue comparison systems

BS 7638:1993 低压径向系统短路电流计算的应用指南

Specifies a standardized procedure developed from BS 7639 for calculation in three-phase a.c. systems operating at 50Hz or 60Hz

Application guide for calculation of short-circuit currents in low-voltage radial systems

NF C44-105:1993 收费表和负载控制用电子脉动控制接收器

Electronic ripple control receivers for tariff and load control.

BOCA CHAPTER 6 NECC-1993 电气系统

The following is a listing of the standards referenced in this code, the effective date of the standard, the promulgating agency of the standard and the section(s) of this code that refer to the standard.

Electrical Systems

BS 7494-1:1991 电力系统远程保护设备的性能和试验.第1部分:窄带指挥系统规范

Applies to narrow-band single-signal and multisignal equipment for teleprotection. Also applies to voice frequency equipment which is used in connection with various telecommunication systems, such as power line carrier, radio link, rented circuits, leased or owned cables.

Performance and testing of teleprotection equipment of power systems - Specification for narrow-band command systems

IEC 61037:1990 计费和负载控制用电子脉动控制接收装置

Electronic ripple control receivers for tariff and load control

BOCA ARTICLE 27 NBC-1990 电气线路,设备和系统.第11版

The BOCA National Mechanical Code was initially prepared and updated on the premise that adequate code requirements are essential to the safe installation and maintenance of all mechanical equipment and systems in order to protect the public health, sa

Electric Wiring, Equipment and Systems Eleventh Edition

BOCA ARTICLE 6 NECC-1990 电气系统

APPENDIX A SYSTEM LAYOUT ILLUSTRATIONS

Electrical Systems

IEC 60781:1989 低压辐射系统短路电流计算的应用指南

Application guide for calculation of short-circuit currents in low-voltage radial systems

CNS 42-1988 电力系统供电频率

本标准规定电力系统及与电力系统联接之自用发电设备之供电频率。

Frequency of Electrical Power System

IEC 60834-1:1988 电力系统遥护设备的性能和试验.第1部分:窄频带指令系统

Performance and testing of teleprotection equipment of power systems; part 1: narrow-band command systems

IEEE Std C92.2-1987 电力系统.在230kV以上电压下运行的交流系统及设备优选额定电压

Power systems; alternating-current electrical systems and equipment operating at voltages above 230 kV nominal; preferred voltage ratings

CNS 4380-1982 控制机构的绝缘距离

本标准适用于频率 50 Hz 或 60 Hz，交流 600V 以下及直流 750V 以下电路用之控制机器绝缘距离。注：所谓控制机器即为接触器，电阻器，控制用操作开关，限制开关，电驿（电动机保护用、控制用），端子盘等器具之及组合之装置，亦包括了半导体组装机器。

Clearances and Creepage Distances for Control Gear

CNS 5314-1980 配电箱

本标准适用于配电箱，包含熔线座、刀型开关、倒板开关及无熔线开关等构成之 AC250V 以下之配电箱。

Panel Board Units