31.220.20 开关 标准查询与下载

JB/T 6526-2006 电动工具用电子调速开关

本标准规定了电动工具用电子调速开关的分类、型号、安全与性能的基本要求及相应的试验方法和检验规则。 本标准适用于一般环境条件下使用的、最高工作电压交流不超过250V、频率为5OHz/6OHz、额定电流不超过32A的单相电动工具用电子调速开关（以下简称开关），这类开关安装在电动工具本体或附件上，作接通与分断电流或改变电动工具的旋转方向、限制空载转速、调节运转速度之用。 在特殊环境下使用的开关或特殊用途的开关需在产品标准中补充规定。

Electronic switches with speed regulator devices for electric tools

UL 1699 BULLETINS-2006 CSDS 09/22/2006 (8p)； CSDS 6/30/2006 (4p)； CSDS 6/29/2006 (2p)； CSDS 06/09/2006 (4p)； CSDS 06/08/2006 (6p)； CSDS 5/5/2006 (4p)

The requirements of this Standard cover arc-fault circuit-interrupters (AFCIs) of the branch/feeder, outlet circuit, portable, and cord type intended for use in dwelling units. These devices are intended to mitigate the effects of arcing faults that may pose a risk of fire ignition under certain conditions if the arcing persists. AFCIs have a maximum rating of 20 A and are intended for use in 120-V ac, 60-HZ circuits. Cord AFCIs are rated up to 30 A. These devices are not intended to detect glowing connections. In these requirements the term device is used generically to apply to all of the devices covered by these requirements and is modified when the requirement does not apply to all types. An AFCI that is also intended to perform other functions, such as overcurrent protection, ground-fault circuit-interruption, surge suppression, any other similar functions, or any combination thereof, shall comply additionally with the requirements of the applicable Standard or Standards that cover devices that provide those functions. This standard contains a supplement covering the requirements for Leakage-Current Detector-Interrupters.

CSDS 09/22/2006 (8p); CSDS 6/30/2006 (4p); CSDS 6/29/2006 (2p); CSDS 06/09/2006 (4p); CSDS 06/08/2006 (6p); CSDS 5/5/2006 (4p)

UL 1699-2006 安全电弧故障断路器的UL标准.第2版

The requirements of this Standard cover arc-fault circuit-interrupters (AFCIs) of the branch/feeder, outlet circuit, portable, and cord type intended for use in dwelling units. These devices are intended to mitigate the effects of arcing faults that may pose a risk of fire ignition under certain conditions if the arcing persists. AFCIs have a maximum rating of 20 A and are intended for use in 120-V ac, 60-HZ circuits. Cord AFCIs are rated up to 30 A. These devices are not intended to detect glowing connections. In these requirements the term device is used generically to apply to all of the devices covered by these requirements and is modified when the requirement does not apply to all types. An AFCI that is also intended to perform other functions, such as overcurrent protection, ground-fault circuit-interruption, surge suppression, any other similar functions, or any combination thereof, shall comply additionally with the requirements of the applicable Standard or Standards that cover devices that provide those functions. This standard contains a supplement covering the requirements for Leakage-Current Detector-Interrupters.

UL Standard for Safety Arc-Fault Circuit-Interrupters Second Edition; Reprint with revisions through and including February 28, 2007

JIS C 5441 AMD 1:2006 电子设备用开关的试验方法(修改件1)

この追補はJIS C 5441:1994と併用されるものであり, JIS C 5441:1994の一部は改正され，この追補に置き換えられる。

Testing methods of switches for use in electronic equipment (Amendment 1)

ANSI/UL 1699-2006 电弧故障断路器的安全标准（2005年12月16日通报）

The following changes in requirements are being proposed: Placement of LCDI Requirements in UL 1699 Supplement SB.

Standard for Safety for Arc-Fault Circuit-Interrupters (Bulletin dated December 16, 2005)

JIS C 5401-4-001:2005 电子设备连接器.第4-001部分:有质量评定的印制电路板连接器.空白详细规范

この規格は，JIS C 5401-4を品種別通則とするブランク個別規格で，電子機器及び電子機器に使用するブリント配線板用コネクタについて規定する。

Connectors for electronic equipment -- Part 4-001: Printed Board Connectors with assessed quality -- Blank Detail Specification

AECMA PREN 4234-2005 航空系列 驱动器尺寸.P2版

This "Aerospace Series" Prestandard has been drawn up under the responsibility of AECMA-STAN (The European Association of Aerospace Industries - Standardization). It is published for the needs of the European Aerospace Industry. It has been technically approved by the experts of the concerned Domain following member comments.

Aerospace Series Clamps, Worm Drive Dimensions, Massess Edition P 2

ANSI/UL 20a-2004 通用速动开关

General-Use Snap Switches

ARMY A-A-52596 VALID NOTICE 1-2004 堕海演练堕海演练按钮位

A-A-52596, dated 21 February 1996, has been reviewed and determined to be valid for use in acquisition

BIT, BUTTON, ROCK DRILL, FOR DRIFTER DRILLS

ARMY A-A-52500 VALID NOTICE 1-2004 公制按钮端拟合的停止制动闭环式电缆和管道的装配

A-A-52500, dated 8 August 1994, has been reviewed and determined to be valid for use in acquisition

CABLE AND CONDUIT ASSEMBLY, PARKING BRAKE-LOOP TYPE, BUTTON END FITTING (METRIC)

DS/EN 196110:2004 分规范：旋转开关 能力批准

Sectional Specification: Rotary switches - Capability approval

DS/CECC 96601:2004 空白详细规范：滑动开关

Blank Detail Specification: Slide switches

DS/CECC 96701:2004 空白详细规范：双列直插式开关

Blank Detail Specification: Dual-in-line switches

SJ 20872-2003 KDB9001型电动波导开关详细规范

Switch, electromative waveguide, type KDB9001 detail specification for

SJ 50734/9-2003 KX105型旋转开关详细规范

Style KX105, switches, rotary, detail specification for

SJ 50734/8-2003 KX031型旋转开关详细规范

Style KX031, switches, rotary, detail specification for

BS CECC 96601:2003 空白详细规范.滑动开关

Blank detail specification - Slide switches

CECC 96601-2002 空白详细规范:滑动开关

A statement of the principal usage features of the device; for example 'Panel mounting, high current, extended life.To include such details as number of circuits, types of contacts, number of indexing positions and distances between two indexed positions; for example 2 circuits, shorting, non-shorting 6 positions x 5,08 mm.

Blank Detail Specification: Slide switches

BS CECC 96601:2002 空白详细规范.滑动开关

Blank Detail Specification: Slide switches Foreword 1 Basic information 1.1 General 1.2 Range and variants available 2 Ratings and characteristics 2.1 Electrical ratings 2.2 Environmental ratings 2.3 Mechanical characteristics 2.4 Electrical characteristics 3 Marking information 4 Ordering information 5 Related documents 6 Certified test records 7 Structural similarity 8 Delayed delivery 9 Additional information (Not for inspection purposes except where stated) 10 Test schedule

Blank detail specification - Slide switches

BS CECC 96701:2002 空白详细规范.双列直插式开关

Blank Detail Specification: Dual-in-line switches Foreword 1 Basic information 1.1 General 1.2 Range and variants available 2 Ratings and characteristics 2.1 Electrical ratings 2.2 Environmental ratings 2.3 Mechanical characteristics 2.4 Electrical characteristics 3 Marking information 4 Ordering information 5 Related documents 6 Certified test records 7 Structural similarity 8 Delayed delivery 9 Additional information (Not for inspection purposes except where stated) 10 Test schedule

Blank detail specification - Dual-in-line switches